SAM9G20 Atmel Corporation, SAM9G20 Datasheet - Page 692

• Manufacturer Part Number: SAM9G20
• Manufacturer: Atmel Corporation

Specifications of SAM9G20

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 400 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 7
• Ssc: 1
• Ethernet: 1
• Sd / Emmc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: Yes
• Adc Channels: 4
• Adc Resolution (bits): 10
• Adc Speed (ksps): 95
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 32
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 0.9 to 1.1
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

37.6.2
Register Name:UDP_GLB_STAT
Access Type: Read-write
This register is used to get and set the device state as specified in Chapter 9 of the USB Serial Bus Specification, Rev.2.0.
• FADDEN: Function Address Enable
Read:
0 = Device is not in address state.
1 = Device is in address state.
Write:
0 = No effect, only a reset can bring back a device to the default state.
1 = Sets device in address state. This occurs after a successful Set Address request. Beforehand, the UDP_FADDR regis-
ter must have been initialized with Set Address parameters. Set Address must complete the Status Stage before setting
FADDEN. Refer to chapter 9 of the Universal Serial Bus Specification, Rev. 2.0 for more details.
• CONFG: Configured
Read:
0 = Device is not in configured state.
1 = Device is in configured state.
Write:
0 = Sets device in a non configured state
1 = Sets device in configured state.
The device is set in configured state when it is in address state and receives a successful Set Configuration request. Refer
to Chapter 9 of the Universal Serial Bus Specification, Rev. 2.0 for more details.
• RSMINPR: Resume Interrupt Request
Read:
0 = No effect.
1 = The pin “send_resume” is set to one. A Send Resume request has been detected and the device can send a Remote
Wake Up.
692
31
23
15
–
–
–
7
–
AT91SAM9G20
UDP Global State Register
30
22
14
–
–
–
6
–
29
21
13
–
–
–
5
–
28
20
12
–
–
–
4
–
RSMINPR
27
19
11
–
–
–
3
26
18
10
–
–
–
2
–
CONFG
25
17
–
–
9
–
1
6384E–ATARM–05-Feb-10
FADDEN
24
16
–
–
8
–
0