SAM9G20 Atmel Corporation, SAM9G20 Datasheet - Page 81

• Manufacturer Part Number: SAM9G20
• Manufacturer: Atmel Corporation

Specifications of SAM9G20

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 400 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 7
• Ssc: 1
• Ethernet: 1
• Sd / Emmc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: Yes
• Adc Channels: 4
• Adc Resolution (bits): 10
• Adc Speed (ksps): 95
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 32
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 0.9 to 1.1
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

13.7
13.7.1
13.8
13.9
6384E–ATARM–05-Feb-10
NAND Flash Boot
SDCard Boot
EEPROM Boot
Supported NAND Flash Devices
The NAND Flash Boot program searches for a valid application in the NAND Flash memory.
If a valid application is found, this application is loaded into internal SRAM and executed by
branching at address 0x0000_0000 after remap. See
more information on Valid Image Detection.
Any 8- or 16-bit NAND Flash Device.
The SDCard Boot program searches for a valid application in the SD Card memory.
(Boot ROM does not support high capacity SDCards.)
It looks for a boot.bin file in the root directory of a FAT12/16/32 formatted SD Card. If a valid file
is found, this application is loaded into internal SRAM and executed by branching at address
0x0000_0000 after remap. This application may be the application code or a second-level
bootloader.
The EEPROM Boot program searches for a valid application in an EEPROM connected to the
TWI address: 0x0050_0000.
If a valid application is found, this application is loaded into internal SRAM and executed by
branching at address 0x0000_0000 after remap. See
more information on Valid Image Detection.
“Valid Image Detection” on page 77
“Valid Image Detection” on page 77
AT91SAM9G20
for
for
81