AD8597 Analog Devices, AD8597 Datasheet - Page 5

• Manufacturer Part Number: AD8597
• Description: Ultralow Distortion, Ultralow Noise Op Amp (single)
• Manufacturer: Analog Devices

Specifications of AD8597

• -3db Bandwidth: 10MHz
• Slew Rate: 14V/µs
• Vos: 10µV
• Ib: 25nA
• # Opamps Per Pkg: 1
• Input Noise (nv/rthz): 1.07nV/rtHz
• Vcc-vee: 10V to 36V
• Isy Per Amplifier: 5mA
• Packages: CSP,SOIC

ABSOLUTE MAXIMUM RATINGS
Table 4.
Parameter
Supply Voltage
Input Voltage
Differential Input Voltage
Output Short-Circuit to GND
Storage Temperature Range
Operating Temperature Range
Lead Temperature Range (Soldering 60 sec)
Junction Temperature
1
Stresses above those listed under Absolute Maximum Ratings
may cause permanent damage to the device. This is a stress
rating only; functional operation of the device at these or any
other conditions above those indicated in the operational
section of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect
device reliability.
If the differential input voltage exceeds 1 V, the current should be limited
to 5 mA.
1
Rating
±18 V
−V ≤ V
±1 V
Indefinite
−65°C to +150°C
−40°C to +125°C
300°C
150°C
IN
≤ +V
Rev. C | Page 5 of 20
THERMAL RESISTANCE
θ
its exposed paddle soldered to a pad (if applicable) on a 4-layer
JEDEC standard PCB with zero air flow.
Table 5.
Package Type
8-Lead LFCSP_VD (CP-8-2)
8-Lead SOIC (R-8) (AD8597)
8-Lead SOIC (R-8) (AD8599)
POWER SEQUENCING
The op amp supplies should be applied simultaneously. The
op amp supplies should be stable before any input signals are
applied. In any case, the input current must be limited to 5 mA.
ESD CAUTION
JA
is specified with the device soldered on a circuit board with
θ
78
140
120
JA
AD8597/AD8599
θ
20
39
36
JC
Unit
°C/W
°C/W
°C/W