ADP3336 Analog Devices, ADP3336 Datasheet - Page 3

• Manufacturer Part Number: ADP3336
• Manufacturer: Analog Devices

ABSOLUTE MAXIMUM RATINGS
Input Supply Voltage . . . . . . . . . . . . . . . . . . . –0.3 V to +16 V
Shutdown Input Voltage . . . . . . . . . . . . . . . . –0.3 V to +16 V
Power Dissipation . . . . . . . . . . . . . . . . . . . Internally Limited
Operating Ambient Temperature Range . . . . –40°C to +85°C
Operating Junction Temperature Range . . . –40°C to +150°C
θ
θ
Storage Temperature Range . . . . . . . . . . . . –65°C to +150°C
Lead Temperature Range (Soldering 10 sec) . . . . . . . . 300°C
Vapor Phase (60 sec) . . . . . . . . . . . . . . . . . . . . . . . . . . 215°C
Infrared (15 sec) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 220°C
CAUTION
ESD (electrostatic discharge) sensitive device. Electrostatic charges as high as 4000 V readily
accumulate on the human body and test equipment and can discharge without detection. Although
the ADP3336 features proprietary ESD protection circuitry, permanent damage may occur on
devices subjected to high-energy electrostatic discharges. Therefore, proper ESD precautions are
recommended to avoid performance degradation or loss of functionality.
This is a stress rating only; operation beyond these limits can cause the device to
be permanently damaged.
JA
JA
4-layer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 110°C/W
2-layer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 153°C/W
A
Pin
No.
1, 2, 3 OUT
4
5
6
7, 8
Mnemonic
GND
FB
SD
IN
PIN FUNCTION DESCRIPTIONS
PIN CONFIGURATION
GND
OUT
OUT
OUT
Output of the Regulator. Bypass to
ground with a 1.0 µF or larger capacitor.
All pins must be connected together for
proper operation.
Ground Pin.
Feedback Input. Connect to an external
resistor divider which sets the output
voltage. Can also be used for further
reduction of output noise (see text for
detail).
Capacitor required if C
Active Low Shutdown Pin. Connect to
ground to disable the regulator output.
When shutdown is not used, this pin
should be connected to the input pin.
Regulator Input. All pins must be con-
nected together for proper operation.
Function
1
2
3
4
(Not to Scale)
ADP3336
TOP VIEW
WARNING!
8
7
6
5
IN
IN
SD
FB
ESD SENSITIVE DEVICE
ADP3336
OUT
> 3.3 µF.