nRF24LE1 Nordic VLSI, nRF24LE1 Datasheet - Page 110

• Manufacturer Part Number: nRF24LE1
• Manufacturer: Nordic VLSI

nRF24LE1 Preliminary Product Specification
11.3.5
The following wakeup sources is available in STANDBY power down mode.
MISCIRQ is set if one of the following take place:
11.3.6
Pin wakeup is configured by two registers, WUOPC1 and WUOPC2
Revision 1.1
Address
•
•
•
(Hex)
0xCE wakeUpOnPinConfig1
0xCF
Addr
0xA5
XOSC16M has started and is ready to be used.
ADC finished with conversion, and data ready.
RNG finished and a new random number is ready
wakeUpOnPinConfig0
Bit
7:6
5:4
3:2
1:0
Name/Mnemonic
Wakeup configuration register – WUCON
Pin wakeup configuration
WUOPC1
WUOPC0
R/W
RW
RW
RW
RW
00: Enable wakeup on RFIRQ if interrupt is enabled (IEN1.1=1)
01: Reserved, not used
10: Enable wakeup on RFIRQ
11: Ignore RFIRQ
00: Enable wakeup on TICK (from RTC2) if interrupt is enabled (IEN1.5=1)
01: Reserved, not used
10: Enable wakeup on TICK
11: Ignore TICK
00: Enable wakeup on WUOPIRQ if interrupt is enabled (IEN1.3=1)
01: Reserved, not used
10: Enable wakeup on WUOPIRQ
11: Ignore WUOPIRQ
00: Enable wakeup on MISCIRQ if interrupt is enabled (IEN1.4=1)
01: Reserved, not used
10: Enable wakeup on MISCIRQ
11: Ignore MISCIRQ
Bit Reset value Type
7:0
7:0
Table 63. WUOPCx registers
Table 62. WUCON register
0x00
0x00
110 of 191
Function
R/W Wake Up On Pin configuration register 1.
R/W Wake Up On Pin configuration register 0.
n = 1: Wake up on pin enabled.
n = 0: Wake up on the corresponding pin dis-
abled.
n = 1: Wake up on pin enabled.
n = 0: Wake up on the corresponding pin dis-
abled.
Description
Reset value 0x00