si4430 Silicon Laboratories, si4430 Datasheet - Page 85

• Manufacturer Part Number: si4430
• Description: Si4430 Ism Transceiver
• Manufacturer: Silicon Laboratories

Register 07h. Operating Mode and Function Control 1
Reset value = 00000001
Name
Type
Bit
Bit
7
6
5
4
3
2
1
0
swres
x32ksel
R/W
Name
D7
swres
enlbd
enwt
pllon
txon
rxon
xton
Software Register Reset Bit.
This bit may be used to reset all registers simultaneously to a DEFAULT state, without the
need for sequentially writing to each individual register. The RESET is accomplished by
setting swres = 1. This bit will be automatically cleared.
Enable Low Battery Detect.
When this bit is set to 1 the Low Battery Detector circuit and threshold comparison will be
enabled.
Enable Wake-Up-Timer.
Enabled when enwt = 1. If the Wake-up-Timer function is enabled it will operate in any
mode and notify the microcontroller through the GPIO interrupt when the timer expires.
32,768 kHz Crystal Oscillator Select.
0:
1:
TX on in Manual Transmit Mode.
Automatically cleared in FIFO mode once the packet is sent. Transmission can be
aborted during packet transmission, however, when no data has been sent yet, transmis-
sion can only be aborted after the device is programmed to “unmodulated carrier” ("Reg-
ister 71h. Modulation Mode Control 2").
RX on in Manual Receiver Mode.
Automatically cleared if Multiple Packets config. is disabled and a valid packet received.
TUNE Mode (PLL is ON).
When pllon = 1 the PLL will remain enabled in Idle State. This will for faster turn-around
time at the cost of increased current consumption in Idle State.
READY Mode (Xtal is ON).
enlbd
R/W
D6
RC oscillator
32 kHz crystal
enwt
R/W
D5
Preliminary Rev. 0.4
x32ksel
R/W
D4
Function
txon
R/W
D3
rxon
R/W
D2
pllon
R/W
D1
Si4430
xton
R/W
D0
85