pca8576d NXP Semiconductors, pca8576d Datasheet - Page 20

• Manufacturer Part Number: pca8576d
• Description: Automotive 40 X 4 Lcd Segment Driver For Low Multiplex Rates Up To 1 4
• Manufacturer: NXP Semiconductors

NXP Semiconductors
PCA8576D
Product data sheet
7.16.2 START and STOP conditions
7.16.3 System configuration
7.16.4 Acknowledge
Both data and clock lines remain HIGH when the bus is not busy.
A HIGH-to-LOW transition of the data line while the clock is HIGH is defined as the START
condition - S.
A LOW-to-HIGH transition of the data line while the clock is HIGH is defined as the STOP
condition - P (see
A device generating a message is a transmitter, a device receiving a message is the
receiver. The device that controls the message is the master and the devices which are
controlled by the master are the slaves (see
The number of data bytes transferred between the START and STOP conditions from
transmitter to receiver is unlimited. Each byte of eight bits is followed by an acknowledge
cycle.
Fig 13. Definition of START and STOP conditions
Fig 14. System configuration
•
•
•
A slave receiver which is addressed must generate an acknowledge after the
reception of each byte.
Also a master receiver must generate an acknowledge after the reception of each
byte that has been clocked out of the slave transmitter.
The device that acknowledges must pull-down the SDA line during the acknowledge
clock pulse, so that the SDA line is stable LOW during the HIGH period of the
acknowledge related clock pulse (set-up and hold times must be taken into
consideration).
SCL
SDA
SDA
SCL
TRANSMITTER/
RECEIVER
MASTER
START condition
All information provided in this document is subject to legal disclaimers.
Figure
S
Automotive 40 x 4 LCD segment driver for low multiplex rates
Rev. 1 — 4 April 2011
13).
RECEIVER
SLAVE
TRANSMITTER/
RECEIVER
SLAVE
Figure
14).
TRANSMITTER
MASTER
STOP condition
PCA8576D
P
TRANSMITTER/
© NXP B.V. 2011. All rights reserved.
RECEIVER
MASTER
mbc622
mga807
SDA
SCL
20 of 42