lpc2470fet208 NXP Semiconductors, lpc2470fet208 Datasheet - Page 34

• Manufacturer Part Number: lpc2470fet208
• Description: Flashless 16-bit/32-bit Micro; Ethernet, Can, Lcd, Usb 2.0 Device/host/otg, External Memory Interface
• Manufacturer: NXP Semiconductors

NXP Semiconductors
LPC2470_0
Preliminary data sheet
7.11.1.1 Features
7.11.2.1 Features
7.11.1 USB device controller
7.11.2 USB Host Controller
7.11 USB interface
The Universal Serial Bus (USB) is a 4-wire bus that supports communication between a
host and one or more (up to 127) peripherals. The Host Controller allocates the USB
bandwidth to attached devices through a token-based protocol. The bus supports hot
plugging and dynamic configuration of the devices. All transactions are initiated by the
host controller.
The LPC2470 USB interface includes a Device, Host, and OTG Controller. Details on
typical USB interfacing solutions can be found in
solutions” on page 60
The device controller enables 12 Mbit/s data exchange with a USB Host Controller. It
consists of a register interface, serial interface engine, endpoint buffer memory, and a
DMA controller. The serial interface engine decodes the USB data stream and writes data
to the appropriate endpoint buffer. The status of a completed USB transfer or error
condition is indicated via status registers. An interrupt is also generated if enabled. When
enabled, the DMA controller transfers data between the endpoint buffer and the USB
RAM.
The Host Controller enables full- and low-speed data exchange with USB devices
attached to the bus. It consists of register interface, serial interface engine and DMA
controller. The register interface complies with the OHCI specification.
•
•
•
•
•
•
•
•
•
•
•
•
•
Fully compliant with USB 2.0 specification (full speed).
Supports 32 physical (16 logical) endpoints with a 4 kB endpoint buffer RAM.
Supports Control, Bulk, Interrupt and Isochronous endpoints.
Scalable realization of endpoints at run time.
Endpoint Maximum packet size selection (up to USB maximum specification) by
software at run time.
Supports SoftConnect and GoodLink features.
While USB is in the Suspend mode, LPC2470 can enter one of the reduced power
modes and wake up on USB activity.
Supports DMA transfers with the DMA RAM of 16 kB on all non-control endpoints.
Allows dynamic switching between CPU-controlled and DMA modes.
Double buffer implementation for Bulk and Isochronous endpoints.
OHCI compliant
Two downstream ports
Support for per-port power switching
Rev. 00.01 — 5 October 2007
Section 11.2 “Suggested USB interface
Fast communication chip
LPC2470
© NXP B.V. 2007. All rights reserved.
34 of 72