zl2006 Intersil Corporation, zl2006 Datasheet - Page 43

• Manufacturer Part Number: zl2006
• Description: Adaptive Digital Dc-dc Controller With Drivers And Current Sharing
• Manufacturer: Intersil Corporation

10. Revision History
FN6850.0
FN6850.1
Rev. #
1.0
1.1
1.2
1.3
1.4
1.5
Initial release.
Soft start delay setting changed from 1 ms to 2 ms on Page 4.
Soft start duration accuracy changed from -0/+4ms to -0.25/+4ms on Page 4.
Clarified frequency selection on Page 20.
Added detail to R1, R2 selection on Page 24.
Corrected number of allowed violations in Table 19 on Page 25.
Formatting changes on Page 26.
Removed DDC address references in Sections 6.10, 6.12, and 6.15.
Updated Ordering Information.
Improved readability in current sharing description.
Added comment that a device set up for tracking must have both Alternate Ramp
Control and Precise Ramp-Up Delay disabled on Page 33.
Clarified DDC pull-up requirement on Page 35.
Corrected ILIM values in Table 22.
Added note in Table 3 and Figure 17 that V
current sensing.
Corrected frequency values in Table 16.
Updated Adaptive Frequency Control description on Page 30.
Added V
Added equation for selecting V
Added procedure for determining SA0, SA1 resistor values in Section 6.9.
Assigned file number FN6850 to datasheet as this will be the first release with an
Intersil file number. Replaced header and footer with Intersil header and footer.
Updated disclaimer information to read “Intersil and it’s subsidiaries including
Zilker Labs, Inc.” No changes to datasheet content
Stamped “Not Recommended for New Designs Recommended Replacement Part
ZL6100”
Added footnote “Limits established by characterization and not production
tested.” to parameters throughout spec table
Added following statement to disclaimer on page 45: “This product is subject
to a license from Power One, Inc. related to digital power technology as set
forth in U.S. Patent No. 7,000,125 and other related patents owned by Power
One, Inc. These license rights do not extend to stand-alone POL regulators
unless a royalty is paid to Power One, Inc.”
Removed note “Limits established by characterization and not production
tested.” from Electrical Specifications table and replaced with standard note in
Min Max columns, “Compliance to datasheet limits is assured by one or more
methods: production test, characterization and/or design.”
43
LIM
for DCR sensing to Table 22.
OUT
Description
in Section 5.3.
ZL2006
OUT
must be less than 4.0 V for DCR
December 15, 2010
November 30, 2010
October 12, 2010
August 9, 2010
February 2009
August 2008
March 2008
April 2008
May 2008
June 2008
Date
FN6850.1