ox16cf950 ETC-unknow, ox16cf950 Datasheet - Page 17

no-image

ox16cf950

Manufacturer Part Number
ox16cf950
Description
Cost Asynchronous Card
Manufacturer
ETC-unknow
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
ox16cf950-TQC60
Manufacturer:
FSC
Quantity:
14
IOIs8
RFU
Audio
PwdDwn
Intr
IntrAck
Note 1
The STSCHG# signal is optional and is not supported on the OXCF950, to reduce the complexity of the device.
Note 2
Audio is not supported on the device.
Note 3
The OXCF950 does not support a specific power down mode, since it is a low power device that features a number of sleep
modes (see Section 7 for further details).
5.5.3
The Pin Replacement Register is implemented to provide information about READY, WP or the BVD[2..1] status when
implementing the I/O interface.
Field
CBVD1
CBVD2
OXFORD SEMICONDUCTOR LTD.
CBVD1
D7
2
3
Pin Replacement Register ‘PRR’ (Offset 0xFC)
CBVD2
D6
R/W
-
R/W
R/W
R
R/W
Description
This bit is set (1) when the corresponding bit, RBVD1, changes state. This bit may also be
written by the host.
This bit is set (1) when the corresponding bit, RBVD2, changes state. This bit may also be
written by the host.
CREA DY
D5
Table 15: Configuration Status Register
If a PCMCIA/CF card is using the I/O interface and this field is reset to zero (0),
the function shall not assert STSCHG#.
If a PCMCIA/CF card is not using the I/O interface or the function’s Pin
Replacement register is not present, this field is undefined and should be
ignored.
The host sets this field to one (1) when it can provide I/O cycles only with an 8-bit
D[7..0] data path. The card is guaranteed that accesses to the 16-bit registers will
occur as two byte accesses rather than as a single 16-bit access.
Reserved. Must be zero (0).
This bit is set to one (1) to enable audio information on SPKR# when the card is
configured.
When the host sets this field to one (1), the function shall enter a power-down
state, if such a state exists.
If a PCMCIA/CF card function does not have a power-down state, the function
shall ignore this field.
Interrupt Request / Acknowledge – This field reports whether the function is
requesting interrupt servicing and may be used to acknowledge the host system
is ready to process another interrupt request from the PCMCIA/CF card.
The function shall set this field to one (1) when it is requesting interrupt service.
The function shall set this field to zero (0) when it is not requesting interrupt
service.
Writes to this field are ignored when the IntrAck field of all Configuration and
Status Registers on the PCMCIA/CF card are reset to zero (0).
Single function cards ignore this field on writes and always return zero (0).
CWProt
D4
RBVD1
D3
RBVD2
D2
OXCF950 DATA SHEET V1.1
RREADY
D1
RWProt
Page 17
D0

Related parts for ox16cf950