ST72F324BJ STMICROELECTRONICS [STMicroelectronics], ST72F324BJ Datasheet - Page 131

• Manufacturer Part Number: ST72F324BJ
• Description: 8-bit MCU, 3.8 to 5.5 V operating range with 8 to 32 Kbyte Flash/ROM, 10-bit ADC, 4 timers, SPI, SCI
• Manufacturer: STMICROELECTRONICS [STMicroelectronics]

ST72324B
11.1.6
Indirect (short)
The pointer address is a byte, the pointer size is a byte, thus allowing 00 - FF addressing
space, and requires 1 byte after the opcode.
Indirect (long)
The pointer address is a byte, the pointer size is a word, thus allowing 64 Kbyte addressing
space, and requires 1 byte after the opcode.
Indirect indexed (short, long)
This is a combination of indirect and short indexed addressing modes. The operand is
referenced by its memory address, which is defined by the unsigned addition of an index
register value (X or Y) with a pointer value located in memory. The pointer address follows
the opcode.
The indirect indexed addressing mode consists of two submodes:
Indirect indexed (short)
The pointer address is a byte, the pointer size is a byte, thus allowing 00 - 1FE addressing
space, and requires 1 byte after the opcode.
Indirect indexed (long)
The pointer address is a byte, the pointer size is a word, thus allowing 64 Kbyte addressing
space, and requires 1 byte after the opcode.
Table 78.
Long and short
Short only
I
Instructions supporting direct, indexed, indirect and indirect indexed
addressing modes
Instructions
LD
CP
AND, OR, XOR
ADC, ADD, SUB, SBC
BCP
CLR
INC, DEC
TNZ
CPL, NEG
BSET, BRES
BTJT, BTJF
SLL, SRL, SRA, RLC, RRC
SWAP
CALL, JP
Logical operations
Bit Test and Jump operations
Call or Jump sub-routine
Load
Compare
Arithmetic Additions/Subtractions operations
Bit Compare
Clear
Increment/Decrement
Test Negative or Zero
1 or 2 Complement
Bit operations
Shift and Rotate operations
Swap nibbles
Function
Instruction set
131/188