MF1S5009DA4 NXP [NXP Semiconductors], MF1S5009DA4 Datasheet - Page 7

• Manufacturer Part Number: MF1S5009DA4
• Description: Mainstream contactless smart card IC for fast and easy solution development
• Manufacturer: NXP [NXP Semiconductors]

NXP Semiconductors
9. Functional description
MF1S5009
Product data sheet
PUBLIC
9.2.1 Request standard / all
9.2.2 Anticollision loop
9.1 Block description
9.2 Communication principle
The MF1S5009 chip consists of a 1 kB EEPROM, RF interface and Digital Control Unit.
Energy and data are transferred via an antenna consisting of a coil with a small number of
turns which is directly connected to the MF1S5009. No further external components are
necessary. Refer to the document
The commands are initiated by the reader and controlled by the Digital Control Unit of the
MF1S5009 according to the access conditions valid for the corresponding sector.
After Power On Reset (POR) the card answers to a request REQA or wakeup WUPA
command with the answer to request code (see
14443A).
In the anticollision loop the identifier of a card is read. If there are several cards in the
operating field of the reader, they can be distinguished by their identifier and one can be
selected (select card) for further transactions. The unselected cards return to the idle state
and wait for a new request command.
The anticollision is done with two cascade levels as defined in ISO/IEC 14443-3, see also
Ref.
•
•
•
•
•
•
•
RF interface:
– Modulator/demodulator
– Rectifier
– Clock regenerator
– Power-On Reset (POR)
– Voltage regulator
Anticollision: Multiple cards in the field may be selected and managed in sequence
Authentication: Preceding any memory operation the authentication procedure
ensures that access to a block is only possible via the two keys specified for each
block
Control and Arithmetic Logic Unit: Values are stored in a special redundant format and
can be incremented and decremented
EEPROM interface
Crypto unit: The CRYPTO1 stream cipher of the MF1S5009 is used for authentication
and encryption of data exchange.
EEPROM: 1 kB is organized in 16 sectors with 4 blocks each. A block contains
16 bytes. The last block of each sector is called “trailer”, which contains two secret
keys and programmable access conditions for each block in this sector.
6.
All information provided in this document is subject to legal disclaimers.
Rev. 3 — 27 July 2010
189131
Ref. 1
for details on antenna design.
Section
Mainstream contactless smart card IC
10.4, ATQA according to ISO/IEC
MF1S5009
© NXP B.V. 2010. All rights reserved.
7 of 32