NAND16GW3F2AN6E NUMONYX, NAND16GW3F2AN6E Datasheet - Page 21

• Manufacturer Part Number: NAND16GW3F2AN6E
• Description: IC FLASH 16GBIT SLC 48TSOP
• Manufacturer: NUMONYX

Specifications of NAND16GW3F2AN6E

• Format - Memory: FLASH
• Memory Type: FLASH - Nand
• Memory Size: 16G (2G x 8)
• Interface: Parallel
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Speed: -

NAND08GW3F2A, NAND16GW3F2A
Figure 6.
6.1.3
I/O0-7
RB
R
After the Sequential Cache Read or Random Cache Read command has been issued, the
Ready/Busy signal goes Low and the status register bits are set to SR5=’0’ and SR6=’0’ for
a period of cache read busy time, t
cache register.
After the cache read busy time has passed, the Ready/Busy signal goes High and the status
register bits are set to SR5=’0’ and SR6=’1’, signifying that the cache register is ready to
download new data. data of the previously read page can be output from the page buffer by
toggling the Read Enable signal. Data output always begins at column address 00h, but the
Random Data Output command is also supported.
Cache read (sequential) operation
Setup
Page program
The page program operation is the standard operation to program data to the memory array.
Generally, data is programmed sequentially, however, the device does support random input
within a page.
The memory array is programmed by page, however, partial page programming is allowed
where any number of bytes (1 to 4224) can be programmed.
The maximum number of consecutive partial page program operations on the same page is
8 (see
exceeding this a Block Erase command must be issued before any further program
operations can take place in that page (see
Within a given block, the pages must be programmed sequentially and random page
address programming is not allowed.
Read
code
00h
Table 15: Program and erase times and program erase endurance
Address
inputs
(Read Busy time)
tBLBH1
Read
code
30h
Busy
(Read Cache Busy time)
Sequential
Cache
Read
code
31h
Repeat as many times as necessary
tRCBSY
RCBSY
, while the device copies the next page into the
Figure 7: Page program
Data outputs
(Read Cache Busy time)
tRCBSY
Cache
Read
3Fh
code
Exit
operation).
Device operations
Data outputs
cycles). After
ai13176b
21/65