NAND16GW3F2AN6E NUMONYX, NAND16GW3F2AN6E Datasheet - Page 7

• Manufacturer Part Number: NAND16GW3F2AN6E
• Description: IC FLASH 16GBIT SLC 48TSOP
• Manufacturer: NUMONYX

Specifications of NAND16GW3F2AN6E

• Format - Memory: FLASH
• Memory Type: FLASH - Nand
• Memory Size: 16G (2G x 8)
• Interface: Parallel
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Speed: -

NAND08GW3F2A, NAND16GW3F2A
1
Description
The NANDxxGW3F2A device belongs to the 4224-byte page family of non-volatile NAND
flash memories. The NANDxxGW3F2A has a density of 8 or 16 Gbits (2 x 8 Gbits). The
device operates from a 3 V power supply.
The address lines are multiplexed with the data input/output signals on a multiplexed x8
input/output bus. This interface reduces the pin count and makes it possible to migrate to
other densities without changing the footprint.
Each block can be programmed and erased up to 100,000 cycles (with error correction code
(ECC) on). A write protect pin is available to provide hardware protection against program
and erase operations.
The devices feature an open-drain, ready/busy output that identifies if the program/erase/
read (P/E/R) controller is currently active. The use of an open-drain output allows the
ready/busy pins of several memories to be connected to a single pull-up resistor.
For each die, the memory array is split into 2 planes of 2048 blocks each. This multiplane
architecture makes it possible to program 2 pages at a time (one in each plane), to erase 2
blocks at a time (one in each plane), or to read 2 pages at a time (one in each plane)
dividing by two the average program, erase, and read times.
The device has the Chip Enable ’don’t care’ feature, which allows the bus to be shared
between more than one memory at the same time, as Chip Enable transition during the
latency time do not stop the read operation. Program and erase operations can never be
interrupted by Chip Enable transition.
The device comes with two security features:
For more details about these security features, contact your nearest Numonyx sales office.
The device is available in TSOP48 (12 × 20 mm) package. and is shipped from the factory
with block 0 always valid and the memory content bits, in valid blocks, erased to ‘1’.
Refer to the list of available part numbers and to
information on how to order these options.
OTP (one time programmable) area, which is a restricted access area where sensitive
data/code can be stored permanently. The access sequence and further details about
this feature are subject to an NDA (non disclosure agreement)
Serial number (unique identifier), which allows the NANDxxGW3F2A to be uniquely
identified. It is subject to an NDA (non-disclosure agreement) and is, therefore, not
described in the datasheet.
Table 23: Ordering information scheme
Description
7/65
for