OM11005 NXP Semiconductors, OM11005 Datasheet - Page 9

• Manufacturer Part Number: OM11005
• Description: DISPLAY QVGA TFT FOR OM10100
• Manufacturer: NXP Semiconductors

Specifications of OM11005

• Accessory Type: LCD Display
• For Use With/related Products: OM10100
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 568-4358

Copyright 2007 © Embedded Artists AB
3.2 inch QVGA TFT Color LCD - User’s Guide
5
6
7
8
9
11-12
13-28
29
30
31
32
33
34
35
36
37
38
On display version 2 a new extra 1x6 pos (100 mil spacing) header connector facing down
exists. See datasheet for details about interface timing.
Pin
41
42
43
44
45
46
CFG2 / DTX1 interface configuration pin (see description above)
CFG3 / DTX2 interface configuration pin (see description above)
CFG4 / BWS0 interface configuration pin (see description above)
BWS1 interface configuration pin (see description above). Not used on version 2.
BWS2 interface configuration pin (see description above). Not used on version 2.
D17-D16 data inputs if 18-bit color depth is used. Not used when 8 or 16-bit
parallel interface is used.
D15-D0 databus. D0-D7 is used for 8-bit parallel interface. D0-D15 is used when
16-bit parallel interface is used.
CS – Chip Select, active low
RST – reset input, active low.
RS – Register Set input. Controls if control registers or display ram is accessed.
Normally connected to A1 if 16-bit parallel interface or A0 if 8-bit interface.
WR/RW – Write strobe, active low, or Read/Write strobe (depending on C86 pin
(v1) or CFG settings(v2))
RD/E – Read strobe, active low, or Enable strobe (depending on C86 pin (v1) or
CFG settings(v2))
SI – Serial Input, if the serial interface is used. Set low if not used.
SCL – Serial Clock, if the serial interface is used. Set low if not used.
SO – Serial Output, if the serial interface is used.
LED_PWM, digital PWM signal input (5-10 kHz) for controlling the backlight.
Low duty cycle = high intensity. Leave open if not used.
LED_SHDN, digital PWM signal input (5-10 kHz) for controlling the backlight.
High duty cycle = high intensity. Leave open if not used.
Description
DOTCLK, needed when using RGB interface
HSYNC, needed when using RGB interface
VSYNC, needed when using RGB interface
DEN, needed when using RGB interface
Touch screen controller CS#
Touch screen controller PENIRQ#
Page 9