LFDAS12XSCT Freescale Semiconductor, LFDAS12XSCT Datasheet - Page 441

no-image

LFDAS12XSCT

Manufacturer Part Number
LFDAS12XSCT
Description
HARDWARE MC9S12XS 48-PIN
Manufacturer
Freescale Semiconductor
Datasheet

Specifications of LFDAS12XSCT

Module/board Type
*
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
For Use With/related Products
-
1
Freescale Semiconductor
MODFEN
n is used later in this document as a placeholder for the selected transfer width.
BIDIROE
SPISWAI
XFRW
SPC0
Field
6
4
3
1
0
Transfer Width — This bit is used for selecting the data transfer width. If 8-bit transfer width is selected, SPIDRL
becomes the dedicated data register and SPIDRH is unused. If 16-bit transfer width is selected, SPIDRH and
SPIDRL form a 16-bit data register. Please refer to
information about transmit/receive data handling and the interrupt flag clearing mechanism. In master mode, a
change of this bit will abort a transmission in progress and force the SPI system into idle state.
0 8-bit Transfer Width (n = 8)
1 16-bit Transfer Width (n = 16)
Mode Fault Enable Bit — This bit allows the MODF failure to be detected. If the SPI is in master mode and
MODFEN is cleared, then the SS port pin is not used by the SPI. In slave mode, the SS is available only as an
input regardless of the value of MODFEN. For an overview on the impact of the MODFEN bit on the SS port pin
configuration, refer to
force the SPI system into idle state.
0 SS port pin is not used by the SPI.
1 SS port pin with MODF feature.
Output Enable in the Bidirectional Mode of Operation — This bit controls the MOSI and MISO output buffer
of the SPI, when in bidirectional mode of operation (SPC0 is set). In master mode, this bit controls the output
buffer of the MOSI port, in slave mode it controls the output buffer of the MISO port. In master mode, with SPC0
set, a change of this bit will abort a transmission in progress and force the SPI into idle state.
0 Output buffer disabled.
1 Output buffer enabled.
SPI Stop in Wait Mode Bit — This bit is used for power conservation while in wait mode.
0 SPI clock operates normally in wait mode.
1 Stop SPI clock generation when in wait mode.
Serial Pin Control Bit 0 — This bit enables bidirectional pin configurations as shown in
mode, a change of this bit will abort a transmission in progress and force the SPI system into idle state.
Bidirectional
Bidirectional
Pin Mode
Normal
Normal
SPC0
0
1
0
1
Table
Table 15-5. Bidirectional Pin Configurations
S12XS Family Reference Manual, Rev. 1.11
Table 15-4. SPICR2 Field Descriptions
BIDIROE
15-3. In master mode, a change of this bit will abort a transmission in progress and
1
X
X
0
1
0
1
1
Master Mode of Operation
Slave Mode of Operation
MISO not used by SPI
Slave Out
Master In
Slave I/O
Description
Slave In
MISO
Section 15.3.2.4, “SPI Status Register (SPISR)
MOSI not used by SPI
Serial Peripheral Interface (S12SPIV5)
Master Out
Master I/O
Master In
Slave In
MOSI
Table
15-5. In master
for
441

Related parts for LFDAS12XSCT