DP83848K-MAU-EK National Semiconductor, DP83848K-MAU-EK Datasheet - Page 11

• Manufacturer Part Number: DP83848K-MAU-EK
• Description: BOARD EVALUATION DP83848K
• Manufacturer: National Semiconductor

Specifications of DP83848K-MAU-EK

• Main Purpose: Interface, Ethernet
• Utilized Ic / Part: DP83848K
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Secondary Attributes: -
• Embedded: -
• Primary Attributes: -
• Lead Free Status / Rohs Status: Not Compliant

1.4 LED INTERFACE
See Table 3 for LED Mode Selection.
1.5 RESET
1.6 STRAP OPTIONS
DP83848K uses many functional pins as strap options. The
values of these pins are sampled during reset and used to
strap the device into specific modes of operation. The strap
option pin assignments are defined below. The functional
pin name is indicated in parentheses.
LED_LINK
LED_SPEED
RESET_N
PHYAD0 (COL)
PHYAD1 (RXD_0)
PHYAD2 (RXD_1)
PHYAD3 (RXD_2)
PHYAD4 (RXD_3)
Signal Name
Signal Name
Signal Name
S, O, PU
S, O, PU
S, O, PU
S, O, PD
Type
Type
Type
I, PU
Pin #
Pin #
Pin #
22
21
23
35
36
37
38
39
LINK LED: In Mode 1, this pin indicates the status of the LINK.
The LED will be ON when Link is good.
LINK/ACT LED: In Mode 2, this pin indicates transmit and receive
activity in addition to the status of the Link. The LED will be ON
when Link is good. It will blink when the transmitter or receiver is
active.
SPEED LED: This LED is ON when DP83848K is in 100Mb/s and
OFF when DP83848K is in 10Mb/s. Functionality of this LED is in-
dependent of the mode selected.
RESET: Active Low input that initializes or re-initializes the
DP83848K. Asserting this pin low for at least 1 s will force a reset
process to occur. All internal registers will re-initialize to their de-
fault states as specified for each bit in the Register Block section.
All strap options are re-initialized as well.
PHY ADDRESS [4:0]: The DP83848K provides five PHY address
pins, the state of which are latched into the PHYCTRL register at
system Hardware-Reset.
The DP83848K supports PHY Address strapping values 0
(<00000>) through 31 (<11111>). A PHY Address of 0 puts the
part into the MII Isolate Mode. The MII isolate mode must be se-
lected by strapping Phy Address 0; changing to Address 0 by reg-
ister write will not put the Phy in the MII isolate mode. Please refer
to section 2.3 for additional information.
PHYAD0 pin has weak internal pull-up resistor.
PHYAD[4:1] pins have weak internal pull-down resistors.
11
A 2.2 k resistor should be used for pull-down or pull-up to
change the default strap option. If the default option is
required, then there is no need for external pull-up or pull
down resistors. Since these pins may have alternate func-
tions after reset is deasserted, they should not be con-
nected directly to VCC or GND.
Description
Description
Description
www.national.com