M30850T2-CPE Renesas Electronics America, M30850T2-CPE Datasheet - Page 14

• Manufacturer Part Number: M30850T2-CPE
• Description: DEV M32C/80/84/85/86 COMPACT EMU
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of M30850T2-CPE

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: M32C/84,85,86
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

M30850T2-CPE User’s Manual
Terminology
Terminology
Some specific words used in this user’s manual are defined as follows:
Emulator M30850T2-CPE
This means the compact emulator (this product) for M32C/80, 84, 85 and 86 Group MCUs.
MCU board M30850T2-EPBM
The MCU board M30850T2-EPBM with an evaluation MCU.
Emulator system
This means an emulator system built around the M30850T2-CPE emulator. The M30850T2-CPE emulator system is
configured with an emulator main unit M30850T2-CPE, M32C compact emulator debugger and host machine.
M32C compact emulator debugger
This means a software tool which you can control the emulator from a host machine through the USB interface.
Firmware
This means a program stored in the flash ROM of the emulator. It analyzes contents of communication with the emulator
debugger and controls the emulator M30850T2-CPE. This program is downloadable from the emulator debugger to upgrade
firmware or to support other MCUs.
Host machine
This means a personal computer used to control the M30850T2-CPE emulator system.
Software break
A software break is a function to break the program before the system executes an instruction at the specified address. The
instruction at the preset address will not be executed.
Hardware break
A hardware break is a function to break the program when the system detects a write/read of data to/from memory or a
leading/trailing edge of the signal entered from the external trace cable. The former break function is called address break; and
the latter break function is called trigger break. While the instruction at the address where the software break is set is not
executed, a hardware break is performed after the specified instruction is executed.
Target MCU
This means the microcomputer you are going to debug.
User system
This means a user’s application system using the microcomputer to be debugged.
User program
This means a user’s application program to be debugged.
Evaluation MCU
This means a microcomputer mounted on the emulator which is operated in the special mode for the emulator.
#
In this user’s manual, this symbol is used to show active LOW. (e.g. RESET#)
REJ10J0865-0300 Rev.3.00 December 16, 2005
Page 12 of 98