M30850T2-CPE Renesas Electronics America, M30850T2-CPE Datasheet - Page 42

• Manufacturer Part Number: M30850T2-CPE
• Description: DEV M32C/80/84/85/86 COMPACT EMU
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of M30850T2-CPE

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: M32C/84,85,86
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

M30850T2-CPE User’s Manual
(1) MCU Power Supply Source Selection Jumper/MCU Power Supply Voltage Selection Jumper
These are the jumper switches to select power supply to the MCU and its power voltage. As shown in Table 2.5 below, set the
switch according to the connection to the user system.
Table 2.5 Setting jumper switches
REJ10J0865-0300 Rev.3.00 December 16, 2005
Note on Setting Jumper Switches:
the user system
Not connected
Connection to
Connected
Always shut OFF the emulator before changing the setting of the jumper switches, and connecting the cable.
Otherwise the internal circuit may cause a break.
When the MCU power supply source selection jumper and MCU power supply voltage selection jumper are set
to INT and 5.0 V respectively, the selection jumper JP1 on the M30850T2-EPBM must be set as VCC1=VCC2
side.
MCU power supply
source selection
jumper (JP1)
EXT
INT
MCU power supply
voltage selection
jumper (JP2)
Invalid
3.3 V
5.0 V
CAUTION
Supplied from the emulator. The MCU operating
voltage is 3.3 V.
Supplied from the emulator. The MCU operating
voltage is 5.0 V.
Supplied from the user system. This emulator
consumes max. 500 mA of electrical current from
the user system.
Description
Page 40 of 98
2. Setup