M30850T2-CPE Renesas Electronics America, M30850T2-CPE Datasheet - Page 28

• Manufacturer Part Number: M30850T2-CPE
• Description: DEV M32C/80/84/85/86 COMPACT EMU
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of M30850T2-CPE

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: M32C/84,85,86
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

M30850T2-CPE User’s Manual
2.6.5 LED Display When the Emulator Starts Up Normally
After the emulator starts up, check the status of the LEDs to see whether the emulator operation is enabled or not. Figure 2.7
shows the positions of the emulator status LEDs.
Figure 2.7 Positions of the system status LEDs and target status LEDs
(1) System status LEDs
Check that the LED1 and LED2 of the system status LEDs are lit immediately after the power is activated. If it is not lit, shut
off the emulator and check the power supply for the emulator is properly connected.
(2) Target status LEDs
Target status LEDs light as shown in Figure 2.8 when the user system is not connected and as shown in Figure 2.9 when a user
system is connected. After turning on the power, only the LED5 (RESET) lights on. Check the target status LEDs
display normally after starting up the emulator debugger.
When the target status LEDs do not display as shown in Figures 2.8 and 2.9, refer to “5. Troubleshooting” (page 90).
Figure 2.8 Target status LEDs display when the emulator starts up normally (when user system not connected)
REJ10J0865-0300 Rev.3.00 December 16, 2005
System status LEDs
Target status LEDs
When the user system NOT connected:
The POWER LED does not light.
: ON
:OFF
POWER
POWER
CLOCK
LED1
RESET
SAFE
RUN
LED3
LED6
LED2
POWER
SAFE
POWER
CLOCK
RESET
RUN
COMPACT EMULATOR
STATUS
SYSTEM
TARGET
STATUS
COMPACT EMULATOR
M30850T2-CPE
MADE IN JAPAN
POWER
CLOCK
RESET
RUN
MADE
POWER USB
5.0V
LED3
LED4
LED5
LED6
J1
J2
EXT
JP1
5.0V
JP2
3.3V
INT
SW1
Page 26 of 98
2. Setup