DSPIC33FJ32GS610-I/PT Microchip Technology, DSPIC33FJ32GS610-I/PT Datasheet - Page 191

• Manufacturer Part Number: DSPIC33FJ32GS610-I/PT
• Description: IC MCU/DSP 32KB FLASH 100TQFP
• Manufacturer: Microchip Technology
• Series: dsPIC™ 33Fr

Specifications of DSPIC33FJ32GS610-I/PT

• Core Processor: dsPIC
• Core Size: 16-Bit
• Speed: 40 MIPs
• Connectivity: I²C, IrDA, LIN, SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, QEI, POR, PWM, WDT
• Number Of I /o: 85
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 24x10b, D/A 1x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 100-TFQFP
• Core Frequency: 40MHz
• Embedded Interface Type: I2C, SPI, UART
• No. Of I/o's: 85
• Flash Memory Size: 32KB
• Supply Voltage Range: 3V To 3.6V
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

FIGURE 9-2:
9.2
The auxiliary clock generation is used for a peripherals
that need to operate at a frequency unrelated to the
system clock such as a PWM or ADC.
The primary oscillator and internal FRC oscillator
sources can be used with an auxiliary PLL to obtain the
auxiliary clock. The auxiliary PLL has a fixed 16x
multiplication factor.
9.3
The reference clock output logic provides the user with
the ability to output a clock signal based on the system
clock or the crystal oscillator on a device pin. The user
application can specify a wide range of clock scaling
prior to outputting the reference clock.
 2010 Microchip Technology Inc.
Source (Crystal, External Clock
Note 1: This frequency range must be satisfied at all times.
Note:
Note:
or Internal RC)
dsPIC33FJ32GS406/606/608/610 and dsPIC33FJ64GS406/606/608/610
Auxiliary Clock Generation
Reference Clock Generation
To achieve 1.04 ns PWM resolution, the
auxiliary clock must be set up for 120 MHz.
If the primary PLL is used as a source for
the auxiliary clock, then the primary PLL
should be configured up to a maximum
operation of 30 MIPS or less.
dsPIC33FJ32GS406/606/608/610 and dsPIC33FJ64GS406/606/608/610 PLL
BLOCK DIAGRAM
Divide by
PLLPRE
2-33
N1
0.8-8.0 MHz
Here
Preliminary
(1)
X
Divide by
PLLDIV
2-513
VCO
M
100-200 MHz
Here
F
VCO
(1)
PLLPOST
Divide by
2, 4, 8
N2
12.5-80 MHz
DS70591C-page 191
Here
(1)
F
OSC