Z8F0213PJ005SC Zilog, Z8F0213PJ005SC Datasheet - Page 129

• Manufacturer Part Number: Z8F0213PJ005SC
• Description: IC ENCORE MCU FLASH 2K 28DIP
• Manufacturer: Zilog
• Series: Encore!® XP®r

Specifications of Z8F0213PJ005SC

• Core Processor: Z8
• Core Size: 8-Bit
• Speed: 5MHz
• Connectivity: IrDA, UART/USART
• Peripherals: Brown-out Detect/Reset, LED, POR, PWM, WDT
• Number Of I /o: 24
• Program Memory Size: 2KB (2K x 8)
• Program Memory Type: FLASH
• Ram Size: 512 x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Oscillator Type: Internal
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 28-DIP (0.600", 15.24mm)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Data Converters: -
• Other names: 269-3461

PS024314-0308
Automatic Powerdown
Single-Shot Conversion
bits of resolution are lost because of a rounding error. As a result, the final value is an
11- bit number.
If the ADC is idle (no conversions in progress) for 160 consecutive system clock cycles,
portions of the ADC are automatically powered down. From this powerdown state, the
ADC requires 40 system clock cycles to powerup. The ADC powers up when a conversion
is requested by the ADC Control register.
When configured for single-shot conversion, the ADC performs a single analog-to-digital
conversion on the selected analog input channel. After completion of the conversion, the
ADC shuts down. Follow the steps below for setting up the ADC and initiating a single-
shot conversion:
1. Enable the acceptable analog inputs by configuring the general-purpose I/O pins for
2. Write the
3. Write to the
4. CEN remains 1 while the conversion is in progress. A single-shot conversion requires
alternate function. This configuration disables the digital input and output drivers.
–
The bit fields in the ADC Control register can be written simultaneously:
–
–
–
–
–
5129 system clock cycles to complete. If a single-shot conversion is requested from an
ADC powered-down state, the ADC uses 40 additional clock cycles to power-up
before beginning the 5129 cycle conversion.
Write the
voltage reference level or to disable the internal reference. The
contained in the
Write to the ANAIN[3:0] field to select from the available analog input sources
(different input pins available depending on the device).
Clear CONT to 0 to select a single-shot conversion.
If the internal voltage reference must be output to a pin, set the
The internal voltage reference must be enabled in this case.
Write the REFSELL bit of the pair {
voltage reference level or to disable the internal reference. The REFSELL bit is
contained in the
Set CEN to 1 to start the conversion.
ADC Control/Status Register 1
ADC Control Register 0
REFSELH
ADC Control/Status Register
ADC Control Register
bit of the pair {
to configure the ADC and begin the conversion.
REFSELH
REFSELH
to configure the ADC
0.
,
,
REFSELL
1.
REFSELL
Z8 Encore! XP
} to select the internal
Product Specification
} to select the internal
Analog-to-Digital Converter
REFSELH
REFEXT
®
F0823 Series
bit to 1.
bit is
119