MC908AZ60AMFUE Freescale Semiconductor, MC908AZ60AMFUE Datasheet - Page 65

• Manufacturer Part Number: MC908AZ60AMFUE
• Description: IC MCU FLASH 8.4MHZ 60K 64QFP
• Manufacturer: Freescale Semiconductor
• Series: HC08r

Specifications of MC908AZ60AMFUE

• Core Processor: HC08
• Core Size: 8-Bit
• Speed: 8.4MHz
• Connectivity: CAN, SCI, SPI
• Peripherals: LVD, POR, PWM
• Number Of I /o: 52
• Program Memory Size: 60KB (60K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 1K x 8
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 15x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 64-QFP
• Processor Series: HC08AZ
• Core: HC08
• Data Bus Width: 8 bit
• Data Ram Size: 2 KB
• Interface Type: SCI, SPI
• Maximum Clock Frequency: 8.4 MHz
• Number Of Programmable I/os: 52
• Number Of Timers: 8
• Operating Supply Voltage: 5 V to 5 V
• Maximum Operating Temperature: + 125 C
• Mounting Style: SMD/SMT
• Development Tools By Supplier: FSICEBASE, M68CBL05CE, ZK-HC08AX-A, M68EM08AS/AZ60AE
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 8 bit, 15 Channel
• Package: 64PQFP
• Family Name: HC08
• Maximum Speed: 8.4 MHz
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

5.5 FLASH-2 Mass Erase Operation
Use this step-by-step procedure to erase the entire FLASH-2 memory to read as logic 1:
Freescale Semiconductor
10. Wait for a time, t
1. Set both the ERASE bit and the MASS bit in the FLASH-2 Control Register (FL2CR).
2. Read the FLASH-2 Block Protect Register (FL2BPR).
3. Write to any FLASH-2 address within the FLASH-2 array with any data.
4. Wait for a time, t
5. Set the HVEN bit.
6. Wait for a time, t
7. Clear the ERASE bit.
8. Wait for a time, t
9. Clear the HVEN bit.
If the address written to in Step 3 is within address space protected by the
FLASH-2 Block Protect Register (FL2BPR), no erase will occur.
A. Programming and erasing of FLASH locations can not be performed by
code being executed from the same FLASH array.
B. While these operations must be performed in the order shown, other
unrelated operations may occur between the steps. Care must be taken
however to ensure that these operations do not access any address within
the FLASH array memory space such as the COP Control Register
(COPCTL) at $FFFF.
C. It is highly recommended that interrupts be disabled during
program/erase operations.
MC68HC908AZ60A • MC68HC908AS60A • MC68HC908AS60E Data Sheet, Rev. 6
NVS
MERASE
RCV
NVHL
.
, after which the memory can be accessed in normal read mode.
.
.
NOTE
NOTE
FLASH-2 Mass Erase Operation
65