UPD78F0555MA-FAA-AX Renesas Electronics America, UPD78F0555MA-FAA-AX Datasheet - Page 612

• Manufacturer Part Number: UPD78F0555MA-FAA-AX
• Description: MCU 8BIT 16-SSOP
• Manufacturer: Renesas Electronics America
• Series: 78K0/Kx2-Lr

Specifications of UPD78F0555MA-FAA-AX

• Core Processor: 78K/0
• Core Size: 8-Bit
• Speed: 10MHz
• Connectivity: I²C, LIN, UART/USART
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 9
• Program Memory Size: 4KB (4K x 8)
• Program Memory Type: FLASH
• Ram Size: 384 x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

78K0/Kx2-L
(1) Interrupt request flag registers (IF0L, IF0H, IF1L, IF1H)
R01UH0028EJ0400 Rev.4.00
Sep 27, 2010
Cautions 1. When operating a timer, serial interface, or A/D converter after standby release, operate it once
The interrupt request flags are set to 1 when the corresponding interrupt request is generated or an instruction is
executed. They are cleared to 0 when an instruction is executed upon acknowledgment of an interrupt request or
upon reset signal generation.
When an interrupt is acknowledged, the interrupt request flag is automatically cleared and then the interrupt routine is
entered.
IF0L, IF0H, IF1L, and IF1H are set by a 1-bit or 8-bit memory manipulation instruction. When IF0L and IF0H, and
IF1L and IF1H are combined to form 16-bit registers IF0 and IF1, they are set by a 16-bit memory manipulation
instruction.
Reset signal generation clears these registers to 00H.
2. When manipulating a flag of the interrupt request flag register, use a 1-bit memory manipulation
If a program is described in C language using an 8-bit memory manipulation instruction such as
In this case, even if the request flag of another bit of the same interrupt request flag register
(IF0L) is set to 1 at the timing between “mov a, IF0L” and “mov IF0L, a”, the flag is cleared to 0 at
“mov IF0L, a”. Therefore, care must be exercised when using an 8-bit memory manipulation
instruction in C language.
after clearing the interrupt request flag. An interrupt request flag may be set by noise.
instruction (CLR1). When describing in C language, use a bit manipulation instruction such as
“IF0L.0 = 0;” or “_asm(“clr1 IF0L, 0”);” because the compiled assembler must be a 1-bit memory
manipulation instruction (CLR1).
“IF0L &= 0xfe;” and compiled, it becomes the assembler of three instructions.
mov a, IF0L
and a, #0FEH
mov IF0L, a
CHAPTER 17 INTERRUPT FUNCTIONS
598