HD64F3048BF25 Renesas Electronics America, HD64F3048BF25 Datasheet - Page 466

• Manufacturer Part Number: HD64F3048BF25
• Description: IC H8 MCU FLASH 128K 100QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300Hr

Specifications of HD64F3048BF25

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 8MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 70
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Section 11 Programmable Timing Pattern Controller
11.4
11.4.1
TP
DMAC, or address output is enabled, the corresponding pins cannot be used for TPC output. The
data transfer from NDR bits to DR bits takes place, however, regardless of the usage of the pin.
Pin functions should be changed only under conditions in which the output trigger event will not
occur.
11.4.2
During non-overlapping operation, the transfer of NDR bit values to DR bits takes place as
follows.
1. NDR bits are always transferred to DR bits at compare match A.
2. At compare match B, NDR bits are transferred only if their value is 0. Bits are not transferred
Figure 11.9 illustrates the non-overlapping TPC output operation.
Rev. 3.00 Sep 27, 2006 page 438 of 872
REJ09B0325-0300
TPC output pin
0
if their value is 1.
to TP
15
Usage Notes
Operation of TPC Output Pins
Note on Non-Overlapping Output
are multiplexed with ITU, DMAC, address bus, and other pin functions. When ITU,
DDR
Q
Figure 11.9 Non-Overlapping TPC Output
Q
NDER
Q
DR
C
D
Compare match A
Compare match B
Q
NDR
D
Internal
data bus