DK-DEV-4CGX150N Altera, DK-DEV-4CGX150N Datasheet - Page 14

• Manufacturer Part Number: DK-DEV-4CGX150N
• Description: KIT STARTER CYCLONE IV GX
• Manufacturer: Altera
• Series: CYCLONE® IV GXr
• Type: FPGAr

Specifications of DK-DEV-4CGX150N

• Contents: Board, Cable, Documentation, Power Supply
• For Use With/related Products: Cyclone IV GX
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 544-2713

4–2
Factory Default Switch Settings
Table 4–1. S8 Dip Switch Settings
Cyclone IV GX Transceiver Starter Kit User Guide
1
2
3
4
Switch
CLKSEL
USER_PGM
MAX_JTAG_EN
PCIE_JTAG_EN
Board
Label
This section shows the factory switch settings for the Cyclone IV GX transceiver
starter board.
switch on the bottom side of the board.
Figure 4–1. Switch Locations and Default Settings on the Board Bottom
To restore the switches to their factory default settings, perform the following steps:
1. Set DIP switch bank (S8) to match
2. Set DIP switch bank (S7) to match
Switch 1 has the following options:
■
■
Switch 2 has the following options:
■
■
Switch 3 has the following options:
■
■
Switch 4 has the following options:
■
■
When on, the onboard clock is used for the FPGA differential clock inputs.
When off, the differential SMA clock is used for the FPGA differential clock
inputs.
When on, the PFL loads the user hardware 1 design on power up.
When off, the PFL loads the factory design on power up.
When on, the MAX II EPM2210 device is removed from the JTAG chain.
When off, the MAX II EPM2210 device is included in the JTAG chain.
When on, the PCIe device is in removed from JTAG chain.
When off, the PCIe device is included in the JTAG chain.
Figure 4–1
ON
1
S8
2
3
shows the switch locations and the default position of each
4
OFF = 1
ON = 0
Function
ON
1
Table 4–1
Table 4–2
S7
2
3
4
ON = 0
OFF = 1
and
and
Figure
Figure
4–1.
4–1.
© March 2010 Altera Corporation
Factory Default Switch Settings
Chapter 4: Board Setup
Position
Default
Off
Off
On
On