DK-DEV-4CGX150N Altera, DK-DEV-4CGX150N Datasheet - Page 15

• Manufacturer Part Number: DK-DEV-4CGX150N
• Description: KIT STARTER CYCLONE IV GX
• Manufacturer: Altera
• Series: CYCLONE® IV GXr
• Type: FPGAr

Specifications of DK-DEV-4CGX150N

• Contents: Board, Cable, Documentation, Power Supply
• For Use With/related Products: Cyclone IV GX
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 544-2713

Chapter 4: Board Setup
Factory Default Switch Settings
Table 4–2. S7 Dip Switch Settings
© March 2010 Altera Corporation
1
2
3
4
Note to
(1) The MSEL0, MSEL1, and MSEL2 switches combine to specify a single device configuration. The default 0, 0, 0 combination corresponds to a
(2) The board ships with a simple design example stored in the EPCS flash memory device.To load the design and see the four user LEDs (D5-D8)
Switch
2.5 v passive serial configuration with the standard power-on-reset delay. For a complete list of MSEL combinations, refer to the
and Remote System Upgrades in Cyclone IV Devices
blink, set the S7.1 - S7.4 switches to on, off, on, on, and power cycle the board. These switch settings corresponds to a 2.5 V active serial
configuration with the standard power-on-reset delay. Source code for the EPCS design resides in the <install
dir>\kits\cycloneIVGX_4cgx15_starter\examples directory.
Table
MSEL0
MSEL1
MSEL2
EPCS_nCS
4–2:
f
Board
Label
(1)
(1)
(1)
(2)
For more information about the FPGA board settings, refer to the
Transceiver Starter Board Reference
Switch 1 has the following options:
■
■
Switch 2 has the following options:
■
■
Switch 3 has the following options:
■
■
Switch 4 has the following options:
■
■
When on, the MSEL0 state is logic low.
When off, the MSEL0 state is logic high.
When on, the MSEL1 state is logic low.
When off, the MSEL1 state is logic high.
When on, the MSEL2 state is logic low.
When off, the MSEL2 state is logic high.
When on, the EPCS device defaults to disabled, but allows the MAX II
device to enable or disable the EPCS device.
When off, the EPCS_nCS signal floats, requiring the MAX II device to
enable or disable the EPCS device.
chapter of the Cyclone IV GX Device Handbook.
Manual.
Function
Cyclone IV GX Transceiver Starter Kit User Guide
Cyclone IV GX
Configuration
Position
Default
Off
On
On
On
4–3