SI4330-B1-FM Silicon Laboratories Inc, SI4330-B1-FM Datasheet - Page 38

• Manufacturer Part Number: SI4330-B1-FM
• Description: IC RCVR ISM 960MHZ 3.6V 20-QFN
• Manufacturer: Silicon Laboratories Inc
• Type: ISM Receiverr

Specifications of SI4330-B1-FM

• Package / Case: 20-QFN
• Frequency: 960MHz
• Sensitivity: -118dBm
• Data Rate - Maximum: 128kbps
• Modulation Or Protocol: FSK, GFSK, OOK
• Current - Receiving: 18.5mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Voltage - Supply: 1.8 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Operating Frequency: 240 MHz to 960 MHz
• Operating Supply Voltage: 3 V
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Supply Current: 18.5 mA
• Package: 20QFN EP
• Maximum Data Rate: 256 Kbps
• Transmission Media Type: Wireless
• Power Supply Type: Analog
• Typical Operating Supply Voltage: 3 V
• Minimum Operating Supply Voltage: 1.8 V
• Maximum Operating Supply Voltage: 3.6 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Applications: -
• Memory Size: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 336-1629-5; SI4330-V2-FM

Si4330-B1
initiated. The timeout period after preamble detections is defined as the value programmed into the sync word
length plus four additional bits.
6.9. Receive Header Check
The header check is designed to support 1–4 bytes and broadcast headers. The header length needs to be set in
register 33h, hdlen[2:0]. The headers to be checked need to be set in register 32h, hdch[3:0]. For instance, there
can be four bytes of header in the packet structure but only one byte of the header is set to be checked (i.e.,
header 3). For the headers that are set to be checked, the expected value of the header should be programmed in
chhd[31:0] in Registers 3F–42. The individual bits within the selected bytes to be checked can be enabled or
disabled with the header enables, hden[31:0] in Registers 43–46. For example, if you want to check all bits in
header 3 then hden[31:24] should be set to FF but if only the last 4 bits are desired to be checked then it should be
set to 00001111 (0F). Broadcast headers can also be programmed by setting bcen[3:0] in Register 32h. For
broadcast header check the value may be either “FFh” or the value stored in the Check Header register. A logic
equivalent of the header check for Header 3 is shown in Figure 17. A similar logic check will be done for Header 2,
Header 1, and Header 0 if enabled.
38
hden[31:24]
chhd[31:24]
rxhd[31:24]
rxhd[31:24]
FFh
WISE
WISE
Equivalence
comparison
BIT
BIT
=
Example for Header 3
bcen[3]
Figure 17. Header
hdch[3]
Rev 1.0
Equivalence
comparison
=
header3_ok