LIS3LV02DQ STMicroelectronics, LIS3LV02DQ Datasheet - Page 34

• Manufacturer Part Number: LIS3LV02DQ
• Description: ACCELEROMETER TRPL AXIS 28QFPN
• Manufacturer: STMicroelectronics

Specifications of LIS3LV02DQ

• Axis: X, Y, Z
• Acceleration Range: ±2g, 6g
• Sensitivity: 1024LSB/g, 340LSB/g
• Voltage - Supply: 2.16 V ~ 3.6 V
• Output Type: Digital
• Bandwidth: 40Hz ~ 2.56kHz Selectable
• Interface: I²C, SPI
• Mounting Type: Surface Mount
• Package / Case: 28-QFN
• Sensing Axis: X, Y, Z
• Acceleration: 2 g, 6 g
• Digital Output - Number Of Bits: 12 bit, 16 bit
• Supply Voltage (max): 3.6 V
• Supply Voltage (min): 2.16 V
• Supply Current: 0.6 mA
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Digital Output - Bus Interface: I2C, SPI
• Body Style: QFPN
• Function: Accelerometer
• Primary Type: Accelerometer
• Range, Measurement: 2/6 g
• Voltage, Supply: 3.6 V
• No. Of Axes: 3
• Ic Interface Type: I2C, SPI
• Sensor Case Style: QFN
• No. Of Pins: 28
• Supply Voltage Range: 2.16V To 3.6V
• Operating Temperature Range: -40°C To +85°C
• Rohs Compliant: Yes
• For Use With: 497-6249 - BOARD EVAL ACCEL DGTL LIS3LV02DQ497-5069 - EVAL BOARD 3AXIS MEMS ACCELLRMTR
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-4919

7 Register Description
7.25
34/42
DD_CFG (38h)
Direction-detector configuration register
IEND
LIR
ZHIE
ZLIE
YHIE
YLIE
XHIE
XLIE
Interrupt enable on Direction change. Default value: 0
(0: disabled;
1: interrupt signal enabled)
Latch Interrupt request into DD_SRC reg with the DD_SRC reg cleared by reading
DD_ACK reg. Default value: 0.
(0: interrupt request not latched;
1: interrupt request latched)
Enable interrupt generation on Z high event. Default value: 0
(0: disable interrupt request;
1: enable interrupt request on measured accel. value higher than preset threshold)
Enable interrupt generation on Z low event. Default value: 0
(0: disable interrupt request;
1: enable interrupt request on measured accel. value lower than preset threshold)
Enable interrupt generation on Y high event. Default value: 0
(0: disable interrupt request;
1: enable interrupt request on measured accel. value higher than preset threshold)
Enable interrupt generation on Y low event. Default value: 0
(0: disable interrupt request;
1: enable interrupt request on measured accel. value lower than preset threshold)
Enable interrupt generation on X high event. Default value: 0
(0: disable interrupt request;
1: enable interrupt request on measured accel. value higher than preset threshold)
Enable interrupt generation on X low event. Default value: 0
(0: disable interrupt request;
1: enable interrupt request on measured accel. value lower than preset threshold)
IEND
LIR
ZHIE
CD00047926
ZLIE
YHIE
YLIE
XHIE
XLIE
LIS3LV02DQ