MF1SPLUS6011DUD/03 NXP Semiconductors, MF1SPLUS6011DUD/03 Datasheet - Page 7

• Manufacturer Part Number: MF1SPLUS6011DUD/03
• Description: RFID Modules & Development Tools MIFARE CRYPTO1 AES 848Kbps 2KB
• Manufacturer: NXP Semiconductors

Specifications of MF1SPLUS6011DUD/03

• Security: MIFARE CRYPTO1, AES
• Product: Smart Card
• Data Rate: 848 Kbps
• Antenna: On-Board
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

NXP Semiconductors
MF1SPLUSX0Y1_SDS_31
Product short data sheet
PUBLIC
8.2.1 Backwards compatibility protocol
8.2.2 ISO/IEC 14443-4 Protocol
There are three different versions of the PICC. The first two have the UID programmed
into a locked part of the NV-memory which is reserved for the manufacturer:
Due to security and system requirements, these bytes are write-protected after being
programmed by the PICC manufacturer at production.
The third version has a pseudo-unique ID according to ISO/IEC 14443-3 and uses the
XFh ID range.‘
The customer must decide which UID length to use when ordering the product, see
Table 2
During personalization, the PICC can be configured to support Random ID in security
level 3. The user can configure whether Random ID or fixed UID shall be used. According
to ISO/IEC 14443-3 (see
Tag 08h, the 3-byte Random Number and the BCC, if Random ID is used. The retrieval of
the UID in this case can be done using the Virtual Card Support Last command (see
Ref.
The backwards compatibility of this product, as used in security level 1 and security
level 2, runs on the same protocol layer as MIFARE Classic 1K and MIFARE Classic 4K.
The protocol is formed out of the following components:
The following security levels can run on this protocol:
The ISO/IEC 14443-4 Protocol (also known as T=CL) is used in many processor cards.
This protocol is used for the MIFARE Plus with the following security levels:
•
•
•
•
•
•
•
•
•
•
•
the first is a unique 7-byte serial number
the second is a unique 4-byte serial number
Frame definition: according to ISO/IEC 14443-3
Bit encoding: according to ISO/IEC 14443-2
Error code handling: handling is proprietary as error codes are formatted in half bytes.
Command specification: commands are proprietary. Please use the specification as in
Ref. 1
MIFARE Plus as described in this document and in
Security Level 0
Security Level 1
Security Level 0: all commands
Security Level 1: only the security level switch and originality function.
Security Level 3: all commands
3) or by reading out block 0.
for ordering information.
and
Ref. 2
All information provided in this document is subject to legal disclaimers.
and the additional commands which are only implemented in
Rev. 3.1 — 19 April 2010
Ref.
5), the first anticollision loop returns the Random Number
187031
Mainstream contactless smart card IC
MF1SPLUSx0y1
Ref.
3.
© NXP B.V. 2010. All rights reserved.
7 of 17