ISP1505ABS,518 NXP Semiconductors, ISP1505ABS,518 Datasheet - Page 41

• Manufacturer Part Number: ISP1505ABS,518
• Description: RF Transceiver USB ULPI TRANSCEIVER
• Manufacturer: NXP Semiconductors

Specifications of ISP1505ABS,518

• Number Of Transceivers: 1
• Esd Protection: YeskV
• Operating Supply Voltage (typ): Not RequiredV
• Operating Temperature Classification: Industrial
• Operating Supply Voltage (max): Not RequiredV
• Operating Supply Voltage (min): Not RequiredV
• Mounting: Surface Mount
• Operating Temperature (max): 85C
• Operating Temperature (min): -40C
• Operating Supply Voltage: 1.65 V to 3.6 V
• Mounting Style: SMD/SMT
• Package / Case: HVQFN-24
• Lead Free Status / RoHS Status: Compliant
• Other names: 935278318518 ISP1505ABS-T

NXP Semiconductors
ISP1505A_ISP1505C_3
Product data sheet
9.12.1 OTG comparators
9.12.2 Pull-up and pull-down resistors
9.12.3 V
9.13 Serial modes
The ISP1505 provides comparators that conform to On-The-Go Supplement to the
USB 2.0 Specification Rev. 1.3 requirements of V
and V
V
are communicated to the link by RXCMDs as described in
comparators is described in
The USB resistors on DP and DM can be used to initiate data-line pulsing SRP. The link
must set the required bus state using mode settings given in
A pull-up resistor, R
allowed to charge V
the V
A pull-down resistor, R
whenever the A-device turns off the V
resistor to ensure V
For details, refer to On-The-Go Supplement to the USB 2.0 Specification Rev. 1.3 .
The ISP1505 supports both 6-pin serial mode and 3-pin serial mode, controlled by
bits 6PIN_FSLS_SERIAL and 3PIN_FSLS_SERIAL of the Interface Control register. For
details, refer to UTMI+ Low Pin Interface (ULPI) Specification Rev. 1.1, Section 3.10 .
Figure 18
respectively.
B_SESS_VLD
BUS
BUS
B_SESS_END
charge and discharge resistors
power.
and
. Comparators are described in
Figure 19
. In this data sheet, V
BUS
UP(VBUS)
BUS
Rev. 03 — 26 August 2008
DN(VBUS)
is below V
above the session valid threshold to request the host to turn on
provide examples of 6-pin serial mode and 3-pin serial mode,
, is provided to perform V
Section 10.1.5
, is provided for a B-device to discharge V
B_SESS_END
BUS
A_SESS_VLD
ULPI HS USB host and peripheral transceiver
power. The B-device can use the pull-down
to
Section
ISP1505A; ISP1505C
before starting a session.
Section
A_VBUS_VLD
and V
7.6. Changes in comparator values
BUS
10.1.8.
B_SESS_VLD
pulsing SRP. A B-device is
Section
, V
Table
A_SESS_VLD
9.5.2.2. Control over
7.
are combined into
© NXP B.V. 2008. All rights reserved.
BUS
, V
. This is done
B_SESS_VLD
40 of 75