MC68306FC16B Freescale Semiconductor, MC68306FC16B Datasheet - Page 135

• Manufacturer Part Number: MC68306FC16B
• Description: IC MPU INTEGRATED 132-PQFP
• Manufacturer: Freescale Semiconductor

Specifications of MC68306FC16B

• Processor Type: M683xx 32-Bit
• Speed: 16MHz
• Voltage: 5V
• Mounting Type: Surface Mount
• Package / Case: 132-MQFP, 132-PQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Features: -

TC1–TC0—Transmitter Commands
MOTOROLA
Reset Mode Register Pointer—The reset mode register pointer command causes the
mode register pointer to point to DUMR1.
Reset Receiver—The reset receiver command resets the channel receiver. The receiver
is immediately disabled, the FFULL and RxRDY bits in the DUSR are cleared, and the
receiver FIFO pointer is reinitialized. All other registers are unaltered. This command
should be used in lieu of the receiver disable command whenever the receiver
configuration is changed because it places the receiver in a known state.
Reset Transmitter—The reset transmitter command resets the channel transmitter. The
transmitter is immediately disabled, and the TxEMP and TxRDY bits in the DUSR are
cleared. All other registers are unaltered. This command should be used in lieu of the
transmitter disable command whenever the transmitter configuration is changed
because it places the transmitter in a known state.
Reset Error Status—The reset error status command clears the channel's RB, FE, PE,
and OE bits (in the DUSR). This command is also used in the block mode to clear all
error bits after a data block is received.
Reset Break-Change Interrupt—The reset break-change interrupt command clears the
delta break (DBx) bits in the DUISR.
Start Break—The start break command forces the channel's TxDx low. If the transmitter
is empty, the start of the break conditions can be delayed up to one bit time. If the
transmitter is active, the break begins when transmission of the character is complete. If
a character is in the transmitter shift register, the start of the break is delayed until the
character is transmitted. If the transmitter holding register has a character, that
character is transmitted after the break. The transmitter must be enabled for this
command to be accepted. The state of the CTS≈ input is ignored for this command.
Stop Break—The stop break command causes the channel's TxDx to go high (mark)
within two bit times. Characters stored in the transmitter buffer, if any, are transmitted.
These bits select a single command as listed in Table 6-8.
MISC2
0
0
0
0
1
1
1
1
Freescale Semiconductor, Inc.
For More Information On This Product,
MISC1
Table 6-7. MISCx Control Bits
0
0
1
1
0
0
1
1
MC68306 USER'S MANUAL
Go to: www.freescale.com
MISC0
0
1
0
1
0
1
0
1
Reset Break-Change Interrupt
Reset Mode Register Pointer
Reset Error Status
Reset Transmitter
Reset Receiver
No Command
Start Break
Stop Break
Command
6-27