ADM7001X-AC-T-1 Infineon Technologies, ADM7001X-AC-T-1 Datasheet - Page 45

• Manufacturer Part Number: ADM7001X-AC-T-1
• Description: IC SWITCH CTRLR 10/100 48LQFP
• Manufacturer: Infineon Technologies

Specifications of ADM7001X-AC-T-1

• Controller Type: Ethernet Switch Controller
• Interface: Serial
• Voltage - Supply: 3.135 V ~ 3.465 V
• Operating Temperature: 0°C ~ 115°C
• Mounting Type: Surface Mount
• Package / Case: 48-LQFP
• For Use With: EASY7001MIIIN - BOARD EVALUATION ADM7001
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Supply: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: ADM7001XACT1; ADM7001XACT1; ADM7001XACT1X; ADM7001XACT1X; ADM7001XACT1XP; SP000076255

guarantee internal Power On Reset Circuit is reset well. Setting the reset bit in the Basic Mode Control activates
software reset
Register (bit 15, register 0
operation has completed, please note that internal SRAM will not be reset during software reset.
Figure 22
Hardware reset operation samples the pins and initializes all registers to their default values. This process includes
re-evaluation of all hardware configurable registers.
A software reset will reset an individual PHY and it does not latch the external pins nor reset the registers to their
respective default value.
Logic levels on several I/O pins are detected during a hardware reset to determine the initial functionality of
ADM7001/X. Some of these pins are used as output ports after reset operation.
Care must be taken to ensure that the configuration setup will not interfere with normal operation. Dedicated
configuration pins can be tied to VCC or Ground directly. Configuration pins multiplexed with logic level output
functions should be either weakly pulled up or weakly pulled down through resistors.
3.5
An analog block is designed for carrier sense detecting. When there is no carrier sense presented on medium
(cable not attached), then "SIGNAL DETECT" will not be ON. Whenever cable is attached to ADM7001/X and the
voltage threshold is above +/- 50mV, then SD will be asserted HIGH to indicate that there is cable attached to
ADM7001/X. All internal blocks except Management block will be disabled (reset) before SD is asserted.
When SD is asserted, internal Auto Negotiation block will be turned on and the 10M transmit driver will also be
turned on for auto negotiation process. Auto negotiation will issue control signals to control 10M receive and 100M
A/D block according to different state in arbitration block diagram. During auto negotiation, all digital blocks except
management and link monitor blocks will be disabled to reduce power consumption.
Whenever operating speed is determined (Either auto negotiation is On or Off), the non-active speed relative
circuit will be disabled all the time to save more power. For example, when corresponding port is operating on 10M,
then 100M relative blocks will be disabled and 10M relative blocks will be disabled whenever corresponding port
is in 100M mode. Auto negotiation block will be reset when SD signal goes from high to low. See
state diagram for this algorithm.
Data Sheet
SMII Write Operation
Power Management
H
). This bit is self-clearing and, when set, will return a value of 1 until the software reset
45
Function Description
Rev. 1.07, 2005-11-25
Figure 23
ADM7001/X
Data sheet
for the