ADM7001X-AC-T-1 Infineon Technologies, ADM7001X-AC-T-1 Datasheet - Page 53

• Manufacturer Part Number: ADM7001X-AC-T-1
• Description: IC SWITCH CTRLR 10/100 48LQFP
• Manufacturer: Infineon Technologies

Specifications of ADM7001X-AC-T-1

• Controller Type: Ethernet Switch Controller
• Interface: Serial
• Voltage - Supply: 3.135 V ~ 3.465 V
• Operating Temperature: 0°C ~ 115°C
• Mounting Type: Surface Mount
• Package / Case: 48-LQFP
• For Use With: EASY7001MIIIN - BOARD EVALUATION ADM7001
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Supply: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: ADM7001XACT1; ADM7001XACT1; ADM7001XACT1X; ADM7001XACT1X; ADM7001XACT1XP; SP000076255

Field
T4
TXF
TXH
TF
TH
T2
Res
SUPR
AN_C
Data Sheet
Bits
15
14
13
12
11
10
9:7
6
5
Type
ro
Description
100Base-T4 Capable
Set to 0 all the time to indicate that the PHY841F does not support
100Base-T4.
100Base-X Full Duplex Capable
Set to 1 all the time to indicate that the PHY841F does support Full
Duplex mode.
100Base-X Half Duplex Capable
Set to 1 all the time to indicate that the PHY841F does support Half
Duplex mode
10M Full Duplex Capable
TP: Set to 1 all the time to indicate that the PHY841F does support 10M
Full Duplex mode.
FX: Set to 0 all the time to indicate that the PHY841F does not support
10M Full Duplex mode
10M Half Duplex Capable
TP: Set to 1 all the time to indicate that the PHY841F does support 10M
Half Duplex mode.
FX: Set to 0 all the time to indicate that the PHY841F does not support
10M Half Duplex mode
100Base-T2 Capable
Set to 0 all the time to indicate that the PHY841F does not support
100Base-T2.
Reserved
Not Applicable
MF Preamble Suppression Capable
This bit is hardwired to 1 indicating that the PHY841F accepts
management frame without preamble. Minimum 32 preamble bits are
required following power-on or hardware reset. One idle bit is required
between any two management transactions as per IEEE 802.3u
specification.
Auto Negotiation Complete
If auto negotiation is enabled, this bit indicates whether the auto
negotiation process has been completed or not.
Set to 0 all the time when Fiber Mode is selected.
0
1
B
B
AN_C_0, Auto Negotiation process not completed
AN_C_1, Auto Negotiation process completed
53
Registers Description
Rev. 1.07, 2005-11-25
ADM7001/X
Data sheet