ICS1893Y-10 IDT, Integrated Device Technology Inc, ICS1893Y-10 Datasheet - Page 101

• Manufacturer Part Number: ICS1893Y-10
• Description: PHYCEIVER LOW PWR 3.3V 64-TQFP
• Manufacturer: IDT, Integrated Device Technology Inc
• Series: PHYceiver™r
• Type: PHY Transceiverr

Specifications of ICS1893Y-10

• Protocol: MII
• Voltage - Supply: 3.14 V ~ 3.47 V
• Mounting Type: Surface Mount
• Package / Case: 64-TQFP, 64-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Number Of Drivers/receivers: -
• Lead Free Status / Rohs Status: Not Compliant
• Other names: 1893Y-10; 800-1934-5; ICS1893Y-10

7.14.1 Node/Repeater Configuration (bit 19.15)
7.14.2 Hardware/Software Priority Status (bit 19.14)
7.14.3 Remote Fault (bit 19.13)
7.14.4 ICS Reserved (bits 19.12:8)
ICS1893Y-10 Rev F 1/20/04
The Node/Repeater Configuration bit directly indicates the state of the NOD/REP input pin. When this bit is
logic:
•
•
There are two primary differences between Node mode and Repeater mode.
•
•
The Hardware/Software Priority Status bit directly indicates the state of the HW/SW pin. When this bit is
logic:
•
•
The ISO/IEC specification defines bit 5.13 as the Remote Fault bit, and bit 19.13 is functionally identical to
bit 5.13. The Remote Fault bit is set based on the Link Control Word received from the remote link partner.
When this bit is a logic:
•
•
See
Zero, the NOD/REP input pin is pulled down, which instructs the operation code to operate in Node
mode.
One, the NOD/REP input pin is pulled up, which instructs the ICS1893Y-10 to operate in Repeater mode.
In Node mode:
In Repeater mode:
Zero, the hardware pins have priority over the (software) register bits for establishing the ICS1893Y-10
configuration.
One, the (software) register bits have priority over the hardware pins for establishing the ICS1893Y-10
configuration.
Zero, it indicates the remote link partner does not detect a Link Fault.
One, it indicates to an STA that the remote link partner detects a Link Fault.
– The SQE Test default setting is enabled.
– The Carrier Sense signal (CRS) is asserted in response to either transmit or receive activity.
– The SQE Test default setting is disabled.
– The Carrier Sense signal (CRS) is asserted in response only to receive activity.
ICS1893Y-10 - Release
Section 7.11.2, “ICS Reserved (bits
Copyright © 2004, Integrated Circuit Systems, Inc.
16.14:11)”, the text for which also applies here.
All rights reserved.
101
Chapter 7 Management Register Set
January, 2004