RC28F128P33BF60A Micron Technology Inc, RC28F128P33BF60A Datasheet - Page 42

• Manufacturer Part Number: RC28F128P33BF60A
• Manufacturer: Micron Technology Inc

Specifications of RC28F128P33BF60A

• Lead Free Status / Rohs Status: Supplier Unconfirmed

Note:
11.2.3
Caution:
Datasheet
42
The device programs the 64-bit and 128-bit user-programmable OTP Register data 16
bits at a time (see
Issuing the Program OTP Register command outside of the OTP Register’s address
space causes a program error (SR.4 set). Attempting to program a locked OTP Register
causes a program error (SR.4 set) and a lock error (SR.1 set).
When programming the OTP bits in the OTP Registers for a Top Parameter Device, the
following upper address bits must also be driven properly: A[Max:17] driven high (V
Locking the OTP Registers
Each OTP Register can be locked by programming its respective lock bit in the Lock
Register. To lock a OTP Register, program the corresponding bit in the Lock Register by
issuing the Program Lock Register command, followed by the desired Lock Register
data (see
addresses of the Lock Registers are 0x80 for register 0 and 0x89 for register 1. These
addresses are used when programming the Lock Registers (see
Identifier Information” on page
Bit 0 of Lock Register 0 is already programmed during the manufacturing process at the
“factory”, locking the lower, pre-programmed 64-bit region of the first 128-bit OTP
Register containing the unique identification number of the device. Bit 1 of Lock
Register 0 can be programmed by the user to lock the user-programmable, 64-bit
region of the first 128-bit OTP Register. When programming Bit 1 of Lock Register 0, all
other bits need to be left as ‘1’ such that the data programmed is 0xFFFD.
Lock Register 1 controls the locking of the upper sixteen 128-bit OTP Registers. Each of
the 16 bits of Lock Register 1 correspond to each of the upper sixteen 128-bit OTP
Registers. Programming a bit in Lock Register 1 locks the corresponding 128-bit OTP
Register.
After being locked, the OTP Registers cannot be unlocked.
Section 6.2, “Device Command Bus Cycles” on page
Figure 36, “OTP Register Programming Flowchart” on page
21).
18). The physical
Table 7, “Device
Order Number: 208034-04
P33-65nm
79).
Jul 2011
IH
).