LPC1820FET100 NXP Semiconductors, LPC1820FET100 Datasheet - Page 78

• Manufacturer Part Number: LPC1820FET100
• Description: The LPC1820FET100 is a high-performance, cost-effective Cortex-M3 microcontroller featuring 168 kB of SRAM, and advanced peripherals including High Speed USB 2
• Manufacturer: NXP Semiconductors

NXP Semiconductors
LPC1850_30_20_10
Preliminary data sheet
7.13.6.1 Features
7.13.7.1 Features
7.13.6 High-speed USB Host/Device/OTG interface (USB0)
7.13.7 High-speed USB Host/Device interface with ULPI (USB1)
7.13.8 LCD controller
Note: Synchronous static memory devices (synchronous burst mode) are not supported.
Remark: USB0 is available on parts LPC1850/30/20 (see
The USB OTG module allows the part to connect directly to a USB host such as a PC (in
device mode) or to a USB device in host mode.
Remark: USB1 is available on parts LPC1850/30 (see
The USB1 interface can operate as a full-speed USB host/device interface or can connect
to an external ULPI PHY for High-speed operation.
Remark: The LCD controller is available on the part LPC1850 only.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Dynamic memory self-refresh mode controlled by software.
Controller supports 2048 (A0 to A10), 4096 (A0 to A11), and 8192 (A0 to A12) row
address synchronous memory parts. That is typical 512 MB, 256 MB, and 128 MB
parts, with 4, 8, 16, or 32 data bits per device.
Separate reset domains allow the for auto-refresh through a chip reset if desired.
Contains UTMI+ compliant transceiver (PHY).
Complies with Universal Serial Bus specification 2.0.
Complies with USB On-The-Go supplement.
Complies with Enhanced Host Controller Interface Specification.
Supports auto USB 2.0 mode discovery.
Supports all high-speed USB-compliant peripherals.
Supports all full-speed USB-compliant peripherals.
Supports software Host Negotiation Protocol (HNP) and Session Request Protocol
(SRP) for OTG peripherals.
Supports interrupts.
This module has its own, integrated DMA engine.
Complies with Universal Serial Bus specification 2.0.
Complies with Enhanced Host Controller Interface Specification.
Supports auto USB 2.0 mode discovery.
Supports all high-speed USB-compliant peripherals if connected to external ULPI
PHY.
Supports all full-speed USB-compliant peripherals.
Supports interrupts.
This module has its own, integrated DMA engine.
All information provided in this document is subject to legal disclaimers.
Rev. 3.1 — 15 December 2011
32-bit ARM Cortex-M3 microcontroller
LPC1850/30/20/10
Table
Table
2).
2).
© NXP B.V. 2011. All rights reserved.
78 of 157