STM32L151VC STMicroelectronics, STM32L151VC Datasheet - Page 45

• Manufacturer Part Number: STM32L151VC
• Description: Ultra-low-power ARM Cortex-M3 MCU with 256 Kbytes Flash, 32 MHz CPU, LCD, USB, 3xOp-amp
• Manufacturer: STMicroelectronics

Specifications of STM32L151VC

• Operating Power Supply Range: 1.65 V to 3.6 V (without BOR) or 1.8 V to 3.6 V
• 7 Modes: Sleep, Low-power run (11 μA at 32 kHz) , Low-power sleep (4.4 μA), Stop with RTC, Stop (650 nA), Standby with RTC, Standby (300 nA)
• Ultralow Leakage Per I/o: 50 nA max
• Fast Wakeup Time From Stop: 8 μs
• Core: ARM 32-bit Cortex™-M3 CPU
• Dma: 12-channel DMA controller
• 11 Timers: one 32-bit and six 16-bit general-purpose timers, two 16-bit basic timers, two watchdog timers (independent and window)

STM32L151xC, STM32L152xC
6
6.1
6.1.1
6.1.2
6.1.3
6.1.4
6.1.5
Electrical characteristics
Parameter conditions
Unless otherwise specified, all voltages are referenced to V
Minimum and maximum values
Unless otherwise specified the minimum and maximum values are guaranteed in the worst
conditions of ambient temperature, supply voltage and frequencies by tests in production on
100% of the devices with an ambient temperature at T
the selected temperature range).
Data based on characterization results, design simulation and/or technology characteristics
are indicated in the table footnotes and are not tested in production. Based on
characterization, the minimum and maximum values refer to sample tests and represent the
mean value plus or minus three times the standard deviation (mean±3Σ).
Typical values
Unless otherwise specified, typical data are based on T
1.65 V ≤ V
tested.
Typical ADC accuracy values are determined by characterization of a batch of samples from
a standard diffusion lot over the full temperature range, where 95% of the devices have an
error less than or equal to the value indicated (mean±2Σ)
Typical curves
Unless otherwise specified, all typical curves are given only as design guidelines and are
not tested.
Loading capacitor
The loading conditions used for pin parameter measurement are shown in
Pin input voltage
The input voltage measurement on a pin of the device is described in
Figure 7.
DD
≤ 3.6 V voltage range). They are given only as design guidelines and are not
Pin loading conditions
Doc ID 022799 Rev 1
Figure 8.
A
A
= 25 °C and T
.
= 25 °C, V
Pin input voltage
SS
.
Electrical characteristics
DD
A
Figure
= 3.6 V (for the
= T
Figure
A
max (given by
8.
7.
45/108