AN2104 Freescale Semiconductor, AN2104 Datasheet - Page 12

• Manufacturer Part Number: AN2104
• Description: Using Background Debug Mode
• Manufacturer: Freescale Semiconductor

Application Note
12
Follow these steps in order:
10. Input $8000 for the base address when prompted.
11. Move jumper W7, on the evaluation board, to the V
12. Select Erase Module.
13. Ensure that the SCI.s19 file is in the S-record in the configuration
14. Select Program Module.
15. After programming is complete, move jumper W7 to the V
16. The SCI.s19 file has now been erased and programmed into the
1. Load P&E’s PKG12Z software.
2. Connect a parallel cable from the host PC to the Cable12 POD.
3. Connect the 6-pin BDM cable from the POD to the evaluation
4. Apply +5 Vdc to P5 of the evaluation board and +12 Vdc to W8.
5. Launch P&E’s WinIDE.
6. Open P&E’s sample code named SCI.
7. Assemble/compile this file. See
8. Launch the programmer. If the correction assistant window opens,
9. Select the 9b32_32k.12p programming algorithm.
Freescale Semiconductor, Inc.
For More Information On This Product,
board making sure that pin 1 of the cable is connected to pin 1 of
the POD and target. On the evaluation board, make sure that
jumpers W3 and W4 are in the EVB positions and jumper W7 is in
the V
select the correct parallel port being used. Defaults should work
for the other options in this window. See
window. If not, select Specify S record and select this file.
position. Do not leave the programming voltage on the FLASH.
FLASH of the MC68HC912B32 using the BDM. Select Verify
Module to verify that this programming is correct. The code also
can be viewed by selecting Show Module at address $8000.
DD
Go to: www.freescale.com
position.
Figure
6.
Figure
7.
PP
position.
DD
AN2104