at90ls8535-8mi ATMEL Corporation, at90ls8535-8mi Datasheet - Page 57

• Manufacturer Part Number: at90ls8535-8mi
• Description: 8-bit Microcontroller With 8k Bytes In-system Programmable Flash
• Manufacturer: ATMEL Corporation

SPI Control Register – SPCR
1041H–11/01
Figure 40. SPI Transfer Format with CPHA = 1 and DORD = 0
• Bit 7 – SPIE: SPI Interrupt Enable
This bit causes the SPI interrupt to be executed if SPIF bit in the SPSR register is set
and the global interrupts are enabled.
• Bit 6 – SPE: SPI Enable
When the SPE bit is set (one), the SPI is enabled. This bit must be set to enable any SPI
operations.
• Bit 5 – DORD: Data Order
When the DORD bit is set (one), the LSB of the data word is transmitted first.
When the DORD bit is cleared (zero), the MSB of the data word is transmitted first.
• Bit 4 – MSTR: Master/Slave Select
This bit selects Master SPI Mode when set (one) and Slave SPI Mode when cleared
(zero). If SS is configured as an input and is driven low while MSTR is set, MSTR will be
cleared and SPIF in SPSR will become set. The user will then have to set MSTR to re-
enable SPI Master Mode.
• Bit 3 – CPOL: Clock Polarity
When this bit is set (one), SCK is high when idle. When CPOL is cleared (zero), SCK is
low when idle. Refer to Figure 39. and Figure 40. for additional information.
• Bit 2 – CPHA: Clock Phase
Refer to Figure 40 or Figure 41 for the functionality of this bit.
Bit
$0D ($2D)
Read/Write
Initial Value
SPIE
R/W
7
0
SPE
R/W
6
0
DORD
R/W
5
0
MSTR
R/W
4
0
CPOL
R/W
3
0
CPHA
R/W
2
0
AT90S/LS8535
SPR1
R/W
1
0
SPR0
R/W
0
0
SPCR
57