at90ls8535-8mi ATMEL Corporation, at90ls8535-8mi Datasheet - Page 92
at90ls8535-8mi
Manufacturer Part Number
at90ls8535-8mi
Description
8-bit Microcontroller With 8k Bytes In-system Programmable Flash
Manufacturer
ATMEL Corporation
Datasheet
1.AT90LS8535-8MI.pdf
(127 pages)
- Current page: 92 of 127
- Download datasheet (3Mb)
Memory
Programming
Program and Data
Memory Lock Bits
Fuse Bits
Signature Bytes
Programming the Flash
and EEPROM
92
AT90S/LS8535
The AT90S8535 MCU provides two Lock bits that can be left unprogrammed (“1”) or can
be programmed (“0”) to obtain the additional features listed in Table 35. The Lock bits
can only be erased with the Chip Erase command.
Table 35. Lock Bit Protection Modes
Note:
The AT90S8535 has two Fuse bits, SPIEN and FSTRT.
•
•
The status of the Fuse bits is not affected by Chip Erase.
All Atmel microcontrollers have a three-byte signature code that identifies the device.
This code can be read in both Serial and Parallel modes. The three bytes reside in a
separate address space.
1. $000: $1E (indicates manufactured by Atmel)
2. $001: $93 (indicates 8K bytes Flash memory)
3. $002: $03 (indicates AT90S8535 device when signature byte $001 is $93)
Note:
Atmel’s AT90S8535 offers 8K bytes of in-system reprogrammable Flash program mem-
ory and 512 bytes of EEPROM data memory.
The AT90S8535 is shipped with the On-chip Flash program and EEPROM data memory
arrays in the erased state (i.e., contents = $FF) and ready to be programmed. This
device supports a high-voltage (12V) Parallel Programming Mode and a low-voltage
Serial Programming Mode. The +12V is used for programming enable only and no cur-
rent of significance is drawn by this pin. The Serial Programming Mode provides a
convenient way to download program and data into the AT90S8535 inside the user’s
system.
The program and data memory arrays on the AT90S8535 are programmed byte-by-byte
in either programming mode. For the EEPROM, an auto-erase cycle is provided within
the self-timed write instruction in the Serial Programming Mode.
During programming, the supply voltage must be in accordance with Table 36.
Mode
Memory Lock Bits
1
2
3
When the SPIEN Fuse is programmed (“0”), Serial Program and Data Downloading
is enabled. Default value is programmed (“0”). The SPIEN Fuse is not accessible in
Serial Programming Mode.
When the FSTRT Fuse is programmed (“0”), the short start-up time is selected.
Default value is unprogrammed (“1”).
1. In Parallel Mode, further programming of the Fuse bits is also disabled. Program the
1. When both Lock bits are programmed (lock mode 3), the signature bytes cannot be
LB1
Fuse bits before programming the Lock bits.
read in Serial Mode. Reading the signature bytes will return: $00, $01 and $02.
1
0
0
LB2
1
1
0
Protection Type
No memory lock features enabled.
Further programming of the Flash and EEPROM is disabled.
Same as mode 2 and verify is also disabled.
1041H–11/01
(1)
Related parts for at90ls8535-8mi
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
INTERVAL AND WIPE/WASH WIPER CONTROL IC WITH DELAY
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Low-Voltage Voice-Switched IC for Hands-Free Operation
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
MONOLITHIC INTEGRATED FEATUREPHONE CIRCUIT
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
AM-FM Receiver IC U4255BM-M
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Monolithic Integrated Feature Phone Circuit
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Multistandard Video-IF and Quasi Parallel Sound Processing
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
High-performance EE PLD
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
8-bit Flash Microcontroller
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
2-Wire Serial EEPROM
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
U6046BREAR WINDOW HEATING TIMER / LONG-TERM TIMER
Manufacturer:
ATMEL Corporation
Datasheet: