STM8/128-MCKIT STMicroelectronics, STM8/128-MCKIT Datasheet - Page 4

• Manufacturer Part Number: STM8/128-MCKIT
• Description: EVAL KIT MOTOR CONTROL STM8S
• Manufacturer: STMicroelectronics
• Series: STM8Sr

Specifications of STM8/128-MCKIT

• Main Purpose: Power Management, Motor Control
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: STM8S2xx
• Primary Attributes: Brushless DC (BLDC) & AC Induction (ACIM) Motors
• Secondary Attributes: Joystick & LCD User Interface
• Processor To Be Evaluated: STM8S
• Data Bus Width: 8 bit
• Operating Supply Voltage: 2.95 V to 5.5 V
• Silicon Manufacturer: ST Micro
• Silicon Core Number: STM8
• Features: Motor Control Applications, The Inverter Is Driven Using The Space Vector PWM Modulation Technique
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 497-10032

Safety warnings
2
2.1
Note:
2.2
2.3
2.4
4/22
Safety warnings
General
In operation, the STM8/128-MCKIT starter kit has non-insulated wires, moving or rotating
parts (when connected to a motor), as well as hot surfaces. In case of improper use,
incorrect installation or misuse, there is danger of serious personal injury and damage to
property. All operations, installation and maintenance are to be carried out by skilled
technical personnel (applicable accident prevention rules must be observed).
When the power board is supplied with voltages greater than 30 V AC/DC, all of the board
and components must be considered “hot”, and any contact with the board must be avoided.
The operator should stay away from the board as well (risk of projection of material in case
of components destruction, especially when powering the board with high voltages).
The rotating parts of motors are also a source of danger.
The STM8/128-MCKIT starter kit contains electrostatic sensitive components which may be
damaged through improper use.
The board's power supply must be electrically insulated before connecting any cables that
link the PC to the board, such as the STX-RLINK or a serial cable. Otherwise an
earth/ground loop would occur, as there is no insulation board.
Intended use
The STM8/128-MCKIT starter kit is made of components designed for demonstration
purposes and must not be included in electrical installations or machinery. Instructions
about the setup and use of the STM8/128-MCKIT starter kit must be strictly observed.
Operation
After disconnecting the board from the voltage supply, several parts and power terminals
must not be touched immediately because of possible energized capacitors or hot surfaces.
Important notice to users
While every effort has been made to ensure the accuracy of all information in this document,
STMicroelectronics assumes no liability to any party for any loss or damage caused by
errors or omissions or by statements of any kind in this document, its updates, supplements,
or special editions, whether such errors are omissions or statements resulting from
negligence, accident, or any other cause.
Doc ID 15774 Rev 2
UM0709