ATA6823-DK Atmel, ATA6823-DK Datasheet - Page 27

• Manufacturer Part Number: ATA6823-DK
• Description: BOARD EVALUATION FOR ATA6823
• Manufacturer: Atmel
• Type: PWM Controllersr

Specifications of ATA6823-DK

• Main Purpose: Power Management, Motor Control
• Embedded: No
• Utilized Ic / Part: ATA6823
• Primary Attributes: Brush DC Motors, 8 ~ 18V, LIN Interface, Watchdog, 5V Regulator
• Secondary Attributes: Cross Conduction, Under/Over Voltage, Short Circuit, & Temperature Protection
• Input Voltage: 8 V to 18 V
• Product: Power Management Modules
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: ATA6823

13. Revision History
4856K–AUTO–01/11
Please note that the following page numbers referred to in this section refer to the specific revision
mentioned, not to this document.
Revision No.
4856K-AUTO-01/11
4856J-AUTO-11/10
4856I-AUTO-01/10
4856H-AUTO-07/09
4856G-AUTO-01/09
4856F-AUTO-01/08
4856E-AUTO-07/07
History
LIN Transceiver part in Section 8 “Electrical Characteristics” on pages 19
to 21 changed
added
Section 10 “Schaffner and Electromagentic Compatibility” on pages 24 to
26 deleted
Section 3.3 “Wake-up and Sleep Mode Strategy” on page 7 changed
Section 8 “Electrical Characteristics” number 4.8b on page 19 added
Table 9-1 “Typical External Components” on page 25 changed
Section 8 “Electrical Characteristics” number 7.31 on page 24 changed
LIN 2.0 to LIN 2.1 in whole document changed
Section 6 “Operating Range” on page 16 changed
Section 3 “General Statement and Conventions” on page 4 deleted
Section 4 “Application” from page 5 to page 24 removed
Figure 3-1 “Wake-up by pin LIN” on page 7 changed
Section 4 “Absolute Maximum Ratings” on page 15 changed
Section 5 “Thermal Resistance” on page 15 changed
Section 6 “Operating Range” on page 16 changed
Section 7 “Noise and Surge Immunity, ESD and Latch-up” on page 16
Section 8 “Electrical Characteristics” on pages 17 to 23 changed
Table 9-1 “Typical External Components” on page 24 changed
Section 10 “Errata” on page 24 added
Section 11 “ESD and Latch-up Requirements” on page 26 deleted
Section 5.4 “5V/3.3V VCC Regulator” on pages 8 to 9 changed
Section 10 “Electrical Characteristics” number 3.3 on page 18 changed
Section 12 “Ordering Information” on page 27 changed
Put datasheet in a new template
Atmel ATA6823
27