DEMOACKIT Freescale Semiconductor, DEMOACKIT Datasheet - Page 16

• Manufacturer Part Number: DEMOACKIT
• Description: KIT DEMO KIT FOR DC9S08A
• Manufacturer: Freescale Semiconductor
• Series: Flexis™r
• Type: MCUr

Specifications of DEMOACKIT

• Contents: Board, 2 Daughter Cards, Cable
• Processor To Be Evaluated: MCF51AC
• Data Bus Width: 32 bit
• Interface Type: USB
• Silicon Manufacturer: Freescale
• Core Architecture: Coldfire, HCS08
• Core Sub-architecture: Coldfire V1, HCS08
• Silicon Core Number: MCF51, MC9S08
• Silicon Family Name: Flexis - MCF51AC, Flexis - S08AC
• Rohs Compliant: Yes
• Tool Type: Demonstration Board
• Cpu Core: HCS08
• For Use With/related Products: MC9S08AC128, MCF51AC256
• For Use With: DEMOACEX - BOARD EXPANSION FOR DEMO KIT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

D E M O A C
TROUBLESHOOTING
The DEMOAC is fully tested and operational before shipping. If it fails to function properly, in-
spect the board for obvious physical damage first. Verify the communications setup as de-
scribed under GETTING STARTED.
Initial Flash Programming
To program target device FLASH initially, or if device FLASH is erased, apply external power
at the PWR jack and set the PWR_SEL option header to VR1. When prompted by P&E soft-
ware to cycle target power, move the PWRSW to the OFF position momentarily then to the ON
position. Otherwise, the BDM will fail to connect to the target device.
Most common problems are related to improperly configured options or communications pa-
rameters.
1.
2.
3.
4.
5.
6.
7.
Contact
complete description of the problem.
If the simulator software requires a device power cycle during FLASH programming, en-
sure the board is powered externally and the PWR_SEL option header is set to VR1.
Verify the +5V voltage indicator is ON.
Verify input power is connected. If powered from an external power source, measure at
least +7V between VR2-1 and VR2-2 using a multi-meter. If powered from the integrated
BDM, measure +5V across capacitor C16
Ensure the PWRSW is in the ON position.
Verify default option jumper settings and RESET the board.
Ensure target module is securely, and correctly, seated on pin headers JM1 – JM4.
If a peripheral feature does not function properly, ensure all USER select jumpers are in-
stalled.
[e-mail]
U S E R
G U I D E
by email for further assistance. Provide board name and a
16
A P R I L
1 0 ,
2 0 0 8