DEMOACKIT Freescale Semiconductor, DEMOACKIT Datasheet - Page 9

• Manufacturer Part Number: DEMOACKIT
• Description: KIT DEMO KIT FOR DC9S08A
• Manufacturer: Freescale Semiconductor
• Series: Flexis™r
• Type: MCUr

Specifications of DEMOACKIT

• Contents: Board, 2 Daughter Cards, Cable
• Processor To Be Evaluated: MCF51AC
• Data Bus Width: 32 bit
• Interface Type: USB
• Silicon Manufacturer: Freescale
• Core Architecture: Coldfire, HCS08
• Core Sub-architecture: Coldfire V1, HCS08
• Silicon Core Number: MCF51, MC9S08
• Silicon Family Name: Flexis - MCF51AC, Flexis - S08AC
• Rohs Compliant: Yes
• Tool Type: Demonstration Board
• Cpu Core: HCS08
• For Use With/related Products: MC9S08AC128, MCF51AC256
• For Use With: DEMOACEX - BOARD EXPANSION FOR DEMO KIT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

D E M O A C
Figure 3: PWR_SEL Option Header
VX_EN Option Header
The VX_EN option header is a 2-pin jumper that connects the target-board voltage rail to IO
connector position J1-1. IO connector position J1-3 connects directly to the ground plane.
This input requires a regulated +5.0V voltage source. This power input is decoupled to mini-
mize noise input but is not regulated. Also, no protection is applied on this input and damage
to the target board may result if over-driven. Do not attempt to power the target board through
this connector while also applying power through the PWR connector as damage to the board
may result.
Power may be sourced to off-board circuitry through the MCU_PORT. The current limitation of
the on-board regulator must be considered when attempting to source power to external cir-
cuitry. Excessive current drain may damage the target board or the on-board regulator. The
figure below shows the VX_EN option header connections.
Figure 4: VX_EN Option Header
MCU Power
Each power input is routed through an option header. The option header is not installed in
default configurations and a cut-trace on each power input provides default connections. To
BDM
BDM
NOTE: The voltage regulator reference designator at the PWR_SEL option header does not
CAUTION: Do not apply power to connector J1 while also sourcing power from either the
NOTE: Do not exceed available current supply from on-board regulator when sourcing power
PWR_SEL
PWR_SEL
VX_EN
VX_EN
•
•
▪
U S E R
▪
• •
• •
match the reference designator of the voltage regulator.
through connector J1 to external circuitry.
ON
OFF
VR1
VR1
G U I D E
PWR connector. Damage to the board may result.
Enable power connection to connector J1
Disable power connection to connector J1
Selects input voltage from POWER connector
NOTE: The VR1 input is connected to the regulator at VR2.
This is an error in the board silkscreen.
Selects input voltage from the integrated BDM
9
A P R I L
1 0 ,
2 0 0 8