ST7MDT2-DVP2/US STMicroelectronics, ST7MDT2-DVP2/US Datasheet - Page 12

• Manufacturer Part Number: ST7MDT2-DVP2/US
• Description: KIT DEVELOPMENT ST7
• Manufacturer: STMicroelectronics
• Series: ST7-DVP2r
• Type: Microcontrollerr

Specifications of ST7MDT2-DVP2/US

• Contents: Main Emulation Board (MEB), Target Emulation Board (TEB), Cables, Power Supply and Documentation
• For Use With/related Products: ST72254, ST72215, ST72216, ST72104, ST72225, ST72213, ST72212, ST72101
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

2 - Getting Started
Note:
2.3
Note:
Caution:
12/82
7
8
9
A TQFP44 passive probe is available for the ST7MDT2-DVP2 but must be ordered
separately. Contact your nearest STMicroelectronics sales representative (see
Installing the hardware
To install the hardware, follow these steps:
1
2
The supplied parallel cable has been tested in order to operate properly on most PCs. Do not
use any other cable, especially if it is longer than the one provided in the kit—the board may
not operate properly.
The cable should be connected directly to the DB-25 female connector of the PC parallel port.
This connector is similar to the one installed on the board. Do not insert any additional cables
or switchboxes between the PC and the board: a malfunctioning of the board may result.
If a dongle is mounted on the PC parallel port, it should not interfere with the programming
board. Should you notice that the board is dysfunctional, remove the dongle and restart the
installation procedure.
3
4
Special precautions are required if you are using the TQFP64 package. Because there is no
Yamaichi socket available specifically for the TQFP64 footprint (a QFP64 Yamaichi socket is
furnished instead), there are special footprint precautions to be taken when designing your
application board (see
page 59).
One Yamaichi QFP64 socket, with its cover, screws and washers. (Not shown.)
One MCU-on-CD CD-ROM.(Not shown.)
This manual.(Not shown.)
Shut down and power-off the PC that is to be connected to the development
board.
Connect one end of the supplied parallel cable to the parallel connector (P2) on
the development board. Connect the other end of the parallel cable to the LPT1
or LPT2 parallel port on your PC.
Connect the two 50-pin passive probe cables to J1 and J2 on the development
board.
To the other ends of the 50-pin cables, connect the passive probe and/or device
adapter corresponding to the MCU package you wish to emulate:
-
-
-
SDIP56 passive probe alone for SDIP56 MCU packages.
TQFP64 passive probe alone for TQFP64 MCU packages.
SDIP56 passive probe with the SDIP42 device adapter for SDiP42 MCU
packages.
Section 5.7.2: QFP64/TQFP64 footprint discrepancy issues
ST7MDT2-DVP2 User Manual
page
77).
on