ST7MDT2-DVP2/US STMicroelectronics, ST7MDT2-DVP2/US Datasheet - Page 14

• Manufacturer Part Number: ST7MDT2-DVP2/US
• Description: KIT DEVELOPMENT ST7
• Manufacturer: STMicroelectronics
• Series: ST7-DVP2r
• Type: Microcontrollerr

Specifications of ST7MDT2-DVP2/US

• Contents: Main Emulation Board (MEB), Target Emulation Board (TEB), Cables, Power Supply and Documentation
• For Use With/related Products: ST72254, ST72215, ST72216, ST72104, ST72225, ST72213, ST72212, ST72101
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

2 - Getting Started
2.4
14/82
Connecting the TQFP64 passive probe to your application board
A Yamaichi QFP64 socket and its cover are provided in the package
(Ref.: DB200). Before going through the procedure, make sure that you were
properly delivered the socket, its cover and its screws and washers.
To connect the TQFP64 passive probe to your application board, proceed as
follows (see following figure for flow order):
1
2
3
If you require supplementary sockets, the commercial references of Yamaichi
QFP64 sockets are given below:
QFP64/TQFP64 Yamaichi socket WITH positioning pins
QFP64/TQFP64 Yamaichi socket WITHOUT positioning pins
Solder the Yamaichi QFP64 socket base onto your application board (see
Section 5.7.2
cover onto its base.
Place the end of the TQFP64 passive probe onto the Yamaichi socket base,
taking care to align pin 1 of your application board with pin 1 of the passive
probe. Pin 1 is indicated by a chamfer on the passive probe and by a little arrow
or chamfer on the Yamaichi socket.
Once placed, you can screw the TQFP64 passive probe onto the Yamaichi
socket using the four threaded holes located on the upper surface of the
passive probe.
Figure 5: Connecting the TQFP64 probe to your application board
probe (Ref.: DB404)
TQFP64 passive
on page 59 for footprint information). Do NOT screw the socket
Application board
2
T wo 50-pin
flat cables
3
1
Y amaichi socket to solder
Threaded holes
ST7MDT2-DVP2 User Manual
IC149-064-108-S5
IC149-064-008-S5