FS2003(US) Equinox Technologies, FS2003(US) Datasheet - Page 16

• Manufacturer Part Number: FS2003(US)
• Description: PROGRAMMER PORTABLE HI-SPEED ISP
• Manufacturer: Equinox Technologies
• Series: FS2003r
• Type: Portable Production ISPr

Specifications of FS2003(US)

• Mfg Application Notes: ASCII Text Control Protocol Appl Note
• Contents: Programmer, Power Supply Adapter, Software, Cables and Documentation
• For Use With/related Products: Atmel/NXP 8051 MCUs and Atmel AVR MCUs
• Other names: 483-1003

1.4 Programmer Specifications Overview
The table below details the hardware specifications for the programmer. Please refer to the stated
section for further information about any specific parameter.
#
1
2
3
4
5
6
7
8
9
FS2003 ISP Programmer - User Guide V1.08 – 1
Parameter
Target Device
Support
Target Device
Programming
Interfaces
Operating modes
On-board FLASH
Memory Store
Project storage in
Memory Store
Keypad entry
Status LED’s
Programmer Display 2 x 16 character Back-lit LCD (backlight configurable)
Target Vcc
Description / comment
See Device Support List
The programmer supports the following programming interfaces:
The programmer supports the following operating modes:
As standard:
Optional chargeable upgrades:
32 Mbits (4 MBytes) FLASH Memory
4 x Push Button - <YES>, <NO>, <UP>, <Down>
3 x Status LED’s located on the programmer:
These LED’s indicate the current status of the programmer.
64 x Independent Programming Projects
<PASS>, <BUSY>, <FAIL>
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Atmel Low Voltage SPI
Atmel High Voltage SPI (+12V Vpp)
Atmel AVR JTAG (chargeable update)
Atmel (formerly Temic) 8051 Boot loader ISP
Philips (NXP) 8051 - Boot Loader ISP
Development Mode (PC controlled)
Project Upload Mode using Upload Wizard (PC
controlled)
Standalone Mode - Keypad + LCD operation
Standalone Mode – Run Target
ConsoleEDS EVAL – Command Line control
Standalone Mode - Remote Controlled via ‘ASCII Text
Communications’ RS-232 Serial Protocol
PC controlled via ISP-PRO software (chargeable
upgrade)
ConsoleEDS PRO – Command Line control
Target Vcc LED will illuminate when Target Vcc voltage is
st
August 08
Refer
to
sect
1.5.1
1.5.2
3.4
13