FS2003(US) Equinox Technologies, FS2003(US) Datasheet - Page 70

• Manufacturer Part Number: FS2003(US)
• Description: PROGRAMMER PORTABLE HI-SPEED ISP
• Manufacturer: Equinox Technologies
• Series: FS2003r
• Type: Portable Production ISPr

Specifications of FS2003(US)

• Mfg Application Notes: ASCII Text Control Protocol Appl Note
• Contents: Programmer, Power Supply Adapter, Software, Cables and Documentation
• For Use With/related Products: Atmel/NXP 8051 MCUs and Atmel AVR MCUs
• Other names: 483-1003

4.6 J6(b) - Equinox 10-way Header (ATtiny11/12/15 HV Interface)
This connection method is suitable for interfacing the programmer to a Target System which features
the following:
The connector supports programming of the Atmel ATtiny11/12/15 microcontrollers in ‘High Voltage
Serial Programming Mode’. This mode requires that a +12.0V Vpp voltage is applied to the RESET
pin of the target device in order to enter programming mode.
To implement this connection, simply plug the 10-way ISP cable into the Programmer J6 header and
plug the other end of the cable into the matching header on the Target System. Please ensure that
you have made the correct connections from the ISP Header to your Target Device.
Pin
No
1
2
3
FS2003 ISP Programmer - User Guide V1.08 – 1
•
•
•
Programmer
Pin name
PROG_VCC
PROG_SPARE
PROG_TSCK2
Equinox 10-way IDC ISP Header
An Atmel ATtiny microcontroller eg. ATtiny11/12/15
Suitable connections to implement ‘High Voltage Serial Programming Mode’.
Programmer
Input /
Output
P
-
O
Figure 4.6.1 – Equinox 10-way IDC Header (J8) viewed from above
Warning!
Connect to
pin on
Target Device
TARGET_VCC
No connect
XTAL1
3. It is possible for +12V to be output on pin 10 of this
4. Connecting to the wrong ISP Header may cause
st
August 08
connector when programming ATtiny11/12/15 devices.
catastrophic damage to the Programmer & Target
System
Description
Target VCC
This pin should be connected to
the Target System Vcc. This
voltage could be used to power
the programmer depending on the
settings of the power
switch/jumper on the programmer.
Spare Programmer I/O pin
This pin is currently a I/O spare pin
which is not used during SPI
programming. In order to use this
pin, the pin state must be setup in
the EQTools <Pre-programming
State Machine> tab.
SCK2 Clock Output
This output pin is used to supply
an external clock signal (SCK2) to
the target microcontroller.
67