FS2003(US) Equinox Technologies, FS2003(US) Datasheet - Page 67

• Manufacturer Part Number: FS2003(US)
• Description: PROGRAMMER PORTABLE HI-SPEED ISP
• Manufacturer: Equinox Technologies
• Series: FS2003r
• Type: Portable Production ISPr

Specifications of FS2003(US)

• Mfg Application Notes: ASCII Text Control Protocol Appl Note
• Contents: Programmer, Power Supply Adapter, Software, Cables and Documentation
• For Use With/related Products: Atmel/NXP 8051 MCUs and Atmel AVR MCUs
• Other names: 483-1003

4.5 J6(a) - Equinox 10-way Header (Generic SPI Interface)
This connection method is suitable for interfacing the programmer to a Target System which features
the following:
This is the favoured ISP connector as it allows the following additional functions:
To implement this connection, simply plug the 10-way ISP cable into the Programmer J6 header and
plug the other end of the cable into the matching header on the Target System.
Pin
No
1
2
64
•
•
•
•
•
Programmer
Pin name
PROG_VCC
PROG_SPARE -
Equinox 10-way IDC ISP Header
An Atmel device which features the 3-wire SPI + RESET Programming Interface
Application of +12V Vpp for ATtiny High Voltage Serial Programming
SCK2 Oscillator for clocking devices during programming
Spare I/O pin which could be used for SPI SLAVE SELECT or to drive an LED on the Target
System
Programmer
Input /
Output
P
Connect to
pin on
Target Device
TARGET_VCC
No connect
Figure 4.5.1 – Equinox 10-way IDC Header (J8) viewed from above
Warning!
1. It is possible for +12V to be output on pin 10 of this
2. Connecting to the wrong ISP Header may cause
FS2003 ISP Programmer - User Guide V1.08 – 1
connector when programming ATtiny11/12/15 devices.
catastrophic damage to the Programmer & Target
System
Description
Target VCC
This pin should be connected to the
Target System Vcc. This voltage
could be used to power the
programmer depending on the
settings of the power switch/jumper
on the programmer.
Spare Programmer I/O pin
This pin is currently a I/O spare pin
which is not used during SPI
programming. In order to use this pin,
the pin state must be setup in the
EQTools <Pre-programming State
Machine> tab.
st
August 2008